0
Will Chevy 350 heads work on a Chevy 305 and what would be the point of doing it benefits and cons?
Wiki User
∙ 16y ago
The heads would bolt on but if the chamber size is bigger you would get a lower compression ratio causing reduced horsepower. If the valves are bigger you could end up with less low-end torque causing the engine to be sluggish at low speeds.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What are the benefits about a memo?
It is short and to the point.
What is the point gap for 283 Chevy 1964 engine?
0.019 point gap
Do glycolipids have hydrophilic heads?
Glycolipids contain hydrophilic heads. These hydrophilic heads interact with each other and form a hydrophilic coating on each side of the bilayer point towards the polar solvent.
Blue car in vantage point?
The little blue Chevy in the car chase? Chevy Astra
Did most professional basketball players shoot above their heads when they were young?
the three-point line the three-point line
How do you create a power point in describing environmental benefits and challenges of urbanization?
Introduction to benefits and challenges of urbanization
What is the point gap for a Chevy 409 engine?
0.019
Is it possible to measure the costs and benefits to people at some point in the future?
Yes, it is possible to measure the costs and benefits of something to people. This can be done now and at some point in the future.
Can 305 cyl heads go on 350?
Yes, but it increases compression a full point.
Where are the front jack points for a 1988 Chevy Celebrity?
this question depends on what type of work you are doing and what type of jack you are going to use. But most cars have a small mark under the body to signify a jack point.
How long does it take to drive from Brisbane to Tweed Heads?
The drive from Brisbane to Tweed Heads takes about an hourand a half, depending on one's starting point, and how much traffic there is.
What is the point gap for a small block Chevy?
32 thousands
