No, even though they look nearly identical. The '92 model is called a 4T-440 transmission which uses a Throttle valve to determine timing, whereas the '96 model is called a 4T60E Transmission, which uses the PCM(Powertrain Control Module) to determine shift points and timing. I think you'll have to stay within a '96 to '99 year model GM vehicle with a 3100 V6.
how can transmission fluid git in the intake
How do you convert the ac in a 1992 Chevy lumina
Hopefully you mean a 1992 Lumina, and yes, most starters are standard.
there is no alternator on the 1992 Lumina its all electric, so there is no need for one.
The Chevy lumina does not have an inertia switch.
Yes it will, I did the interchange on mine
Loosen the rear transmission mount retaining bolt. Jack the transmission up a couple of inches. Remove the retaining bolt and the transmission mount.
under the engine
ype your answer here...
It is quite easy to install the 1992 Chevy Lumina brake light switch. The brake light switch simply plugs in and out.
Where do I find a fuse panel diagram for a 1992 chevy luman
Yes, there is a windshield wiper relay on a 1992 Chevy Lumina. The windshield wiper relay is located in the underhood fuse panel.
Just go to Google and search for '1992 Chevy lumina wiring harness' up will pop 20 or a 1000 places willing to sell you one.
Remove the cylinder head from your 1992 Chevy Lumina engine. Remove the head gasket and clean the surface. Put the new head gasket on and reverse the process.
Yes, he did. Dale Sr. drove an all black #3 Chevy Lumina during the 1992 Winston Cup season.
My 1990 Lumina 3.1 had the same problem and it was caused by the crank sensor.
17 city 26 highway :(
yes but make sure to use the speedometer cable from the lumina "if the tires are same size"or it will be off.
between starter housing & block
Not unless the 1992 is 4x4.
Your 1992 Chevy Lumina will run with a bad 02 sensor. The engine will seem to be sluggish and the fuel mileage will go down.
The easiest way to reset the ABS light in a 1992 Chevy Lumina is to disconnect the battery for about 30 minutes. When it is reconnected, the light should be reset.
its under the air filter box and below the exhoust manifold