Look on the appliance's data label. There are many appliances that will allow 50 - 60 Hz operations. Also there should be a 1 -800 number on the back of the operation manual. Call them and ask if the unit can be used on both frequencies.
Nope. The power delivered by the 60Hz line will burn it up.
AnswerAbsolutely no problem whatsoever. Resistive loads (heaters) aren't affected by such frequency differences.
Fifty Hertz appliances that have strictly resistive loads will not be affected what so ever when connected to a 60 Hertz supply. The problem is that homes in North America use a 120 volt outlets so a dedicated 240 volt circuit will have to be installed and used strictly for the coffee machine. The cost of installing this dedicated circuit will probably cost more that it would to buy a coffee machine that operates on 120 volts.
An electric kettle's element is a resistive component, which is not affected by frequency. So, yes, the kettle will work with both 50 and 60 Hz.
It would involve some electronics work but it could be done. Might add that it could be more expensive than just buying the proper power supply. Use Use 220V 60hz motor to run 110V 50hz Generator.
Depends. Some smaller stuff can usually run on both, in which case it will be printed on them. If it isn't, you can't run a 220v item on 110v.
no way because frequency cannot change
The internal working of the motor is designed for 110V/60Hz. Your stepdown converter is from 220V/50Hz to 110V/50Hz. Frequency converters from 50Hz to 60Hz are very expensive (many times the cost of a new clipper). Therefore it is better you get a clipper designed for 220V/50Hz. If you still like to put your clipper to use, then the most cost effective solution would be to get a "car inverter" that would convert 12V DC to 110V/60Hz AC.
You can but it would be wise not to. Most 60hz appliances will not work at 50 Hz. <<>> Yes, no problem at all. The frequency does not enter into the equation because the hot plate is a strictly resistive load.
Yes, no problem.
nothing
No
you can't
No, 120 v is not enough.
Yes no problem the transformer should run a little cooler as well.
Yes, using a 220v-60hz microwave in Australia is fine. The voltage of alternating current supplied to homes in Australia is 220v. The frequency of the voltage is 50hz.
Nothing happens. The stereo has a transformer that converts the power to DC, and 50 or 60 Hz input makes no difference.
More than likely yes it will work just fine.
yes.
Most likely, yes. Most devices has been manufactured with an idea that they will be used in areas where the supply power frequency is 50 or 60Hz.
The compressor may run slightly faster, but little else. You should get away with it without damage. Any timer circuits may be inaccurate.