0
Yes it will but not transversly as the Mazda engine is<It will have to sit longitudely north/south<This will require custom motor mounts, custom crossmember,custom driveshaft,custom rear suspension,control arms,rear differential,axles,brakes,etc gas tank
not to mention new gas lines,vaccuums,misc lines etc..The cars dash will not work as it was intended for a Mazda engine and the sensors are incompatible...You can get a Mazda 929 rear cradle and custom fab control arms....Measurements are really close between the cars....
Thecarguy84@live.com
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you fix a 1993 Nissan 240sx from sputtering?
Tune up.
How do you fix a window that will not go up or down in a 1990 Nissan 240sx?
Replace the window regulator
Auto 95 Nissan 240sx reverse stopped working......get a new car or fix it?
Is this Joe from liverpool!? XD
How do you fix a 1990 Nissan 240sx gas gauge not registering gas?
Have you checked the gas floater in the gas tank?
There is a grinding in my rear wheels in my 89 Nissan 240sx when i reverse what is ithow do i fix it?
Brakes or wheel bearings. Have it looked into ASAP.
How can you fix timing chain of Mazda 6 2004 2.3L engine?
You fix it by replacing it.
How do you fix the hood on a 1990 Nissan 240sx?
Running into a tree works well. Hammers will also do the trick, but take a little more time.
How do you reset the check engine light on a 1996 Nissan 240SX?
First fix the problem that caused the light to come on. Then you may be able to reset it by removing the battery cable for 5 minutes. If that does not work, you will need an OBD2 scan tool to reset the light.
How do you fix blinkers and hazards that stop functioning on a 92 Nissan 240SX?
this could be a blown fuse, defective flasher, loose connection, or burned out bulb tk
How do you fix engine smoke in a Mazda Miata?
possibley change the valve guide seals
How do you fix a 1981 Mazda 323 clutch?
unbolt tranny from engine clutch is between them
How to fix a clucth problem with a 240sx 1992 Nissan. just recently replaced the clucth leaving the old bearing on it is still having the clucth to slip what do i do?
you might have put the clutch in backward........
