Yes, it could.
where is the crankshaft sensor located on a 1993 dodge intrepid
CMP : camshaft position sensorCKP : crankshaft postion sensor.CMP : camshaft position sensorCKP : crankshaft postion sensor.
It can, but not always.
It should be on the transmission by the passenger side of car. It has three wires connected to it.
passenger side in the transmission bell housing.
It is on the passenger side of the bell housing about half way up.
looks similar to the camshaft sensor, but it's located in the bell housing on the transmission on passenger side.
Yes
the crank sensor is on the passenger side of the car on the back of the engine. Check right up there by the transmission housing.
CRANKSHAFT POSITION SENSOR The crankshaft sensor is located on the passengers side of the transmission housing, above the differential housing Crankshaft Position Sensor The bottom of the sensor sits above the drive plate REMOVAL Disconnect electrical connector from crankshaft position sensor. Remove sensor mounting screw. Remove sensor. INSTALLATION Install sensor and push sensor down until contact is made with the transmission case. While holding the sensor in this position, install and tighten the retaining bolt to 12 N·m (105 in. lbs.) torque. Connect electrical connector to crankshaft position sensor.
No. The camshaft position sensor and crankshaft position sensor tone wheels are different. It may fit, but the engine will not run.
It's located at the right (passenger) side of the transaxle bellhousing.