Yes, it can.
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
Have electronic vehicle speed sensor in transmission checked out. It will cause loss of speedometer function and set a fault code(check engine light).
The coomputer detected a fault in one of the sensors or the engine, transmission, ABS, or EVAP system is malfunctioning
P0700 is EATX code present.It simply means that the engine computer has noticed that the transmission computer has a dtc in it. This causes the Pcm (engine computer) to turn the check engine light on. You will need to have the TCM (trans computer) checked for codes to know what to diagnose.General automatic transmission fault. It could be a sticky internal sensor. A transmission shop could read the actual fault from the transmission.
Check VSS or wiring to it could cause fault .does speedometer work?
An engine light check means some fault in the engine . Check the handbook to get more details to find what and where the fault is.
The transmission codes and functions are often controlled by the ecm, engine control module computer. The ecm stores the fault codes from the engine and transmission. It is telling you that you have a transmission problem, the vehicle must have the ecm scanned by a certified technician, to properly diagnose the problem.
If your car jerks, you likely have stepped on the gas pedal a bit too hard but it could be an indication that there is something wrong with the engine or transmission If your engine is at fault it likely be the engine coil, pistons, cylinders, or head gasket if any are cracked or missing parts or just from wear and tear it can cause jerking of the engine... if it is the engine it is a minor problem but if you have it like that enough time of shifting and driving normally... it can cause more problems to the engine then the expense to fix it could be huge If it is a transmission problem, the gear and the mechanism is not functioning properly. A faulty transmission can cause unwanted jerking if it does not go into the proper gear as selected. This could be from a bad transmission, blown transmission or the lack of transmission fluid which is critical for the gears to change properly without it the mechanism will no support when the gear changes it simply just wont function correctly. If the transmission is at fault it is obviously critical to get it fixed before you cause serious damage to your car....
You can use a scan tool or unhook the battery after repairing the cause of the fault.
you need to have the check engine/service engine soon fault codes read to determine what the fault is.
code 26/quad driver module fault. I have a vibration when I acceleration at times. What is the cause? I have a 1990 oldsmobile cutlass cierra, 3.3 liter V6 engine. The engine light comes on and off. what is the possible cause?
On a Chrysler vehicle the engine computer sets P0700 whenever the transmission computer has detected and set a fault. You will need to have transmission codes checked to know possible causes.On a Chrysler vehicle the engine computer sets P0700 whenever the transmission computer has detected and set a fault. You will need to have transmission codes checked to know possible causes.