Yes, that is why it's magnetised.
An ordinary steel sewing needle is easy to magnetize.
the magnetic materials that can conduct electricity is iron, steel, nickel and colbalt. thats what i found on the internet
You just stroke it in the same direction a few dozen times with just one pole of a powerful permanent magnet.The screwdriver must be made of of iron or steel: it won't work if the screwdriver is made of something like brass, aluminum or plastic because those materials are non-magnetic!Lots of people try to make a magnet using both poles of a horseshoe-shaped magnet but then it won't work as well because the second pole of the magnet will reverse the magnetising effect of the first pole.All you have to do is keep stroking the metal with just one pole of your magnet, pressing hard and always going in just one direction only and then pick up the magnet at the end of each stroke.Stroke the metal over and over like that with just one pole of your magnet until the metal of the screwdriver gets magnetized enough to pick up other pieces of metal, like a smaller screwdriver or some metal paperclips.But be sure to to try your magnetized screwdriver only on other things that are also made of a magnetizable material such as steel.
There are a few ways . . . 1. Point the screwdriver north and south, then tap on it for a while with a hammer or other steel device. 2. Rub the screwdriver for its entire length with a magnet for a while.
For magnets to attract each other they must show (each other) opposite poles. To stick to a non-magnetized piece of steel, the magnet induces a temporary field in the steel - which is always the correct polarity for attraction.
Rub it against a magnet repeatedly. * The screwdriver can only be magnetized if made from steel or another magnetic metal, and most of them are. * Once magnetized, the screwdriver will remain magnetized always.
If your screwdriver blade is magnetised it will attract regular steel screws but not stainless steel or those with a coating.
Yes, if a nail is made of steel, it will will not be magnetized unless it is magnetized by a magnet by being hit.
So steel screws will stick to it while you are inserting them. This is particularly useful if you are putting small screws in awkward holes
A screwdriver head is normally made of toughened/hardened steel or chromium plated steel. Depending on the quality of the screwdriver.
compass
Doubt it because the piece of steel is not magnetized.
Most steels can be magnetized, but not all. Some stainless steel alloys are not magnetic.
An ordinary steel sewing needle is easy to magnetize.
A bullet could only become magnetized if made with a metal that can be (i.e. steel) and through normal methods like friction, magnetic induction, etc.
Usually steel .
High carbon steel