Not enough to notice.
between torque converter and engine
Adding the wedge spacer plate will enhance or increase the performance.
your spacer plate and starter should be the same the flex plate and converter will need to be replaced
As long as it is between the air filter and the throttle plate/throttle body.
Between the air filter and the throttle plate.
The difference would in most cases be negligible, but the simple andswer is better. I would place the nitrous plate underneath your carb spacer right on top of the intake manifold if it is a multiholed spacer. Reason being is that if you have a multihole spacer, it may interfere with the nitrous flow and cause the atomized nitrous and gas to drop out of suspension and puddle. This can cause very bad issues if it builds up and there is a back fire through the intake. However the issue isn`t as much of a problem with an open spacer as there is negligible difference in flow impedance. Now the opposite might be true if you have a very low profile intake. In that case I recommend above an open spacer as it will keep the nitrous jetting from hitting the intake floor, which also would result in some loss of atomized mixture. Hope this has helped
The on l y adjustment on the crank sensor is accomplished by gluing a specific thickness spacer to the tip before installation. The spacer is pushed against the flex plate as the bolt is tightened. The spacer is available from the dealer.
I have a 330T O/U trap gun. The butt pad on it is black, ventilated (vertical rectangles), and has a black spacer and a slimmer white spacer (the spacer(s) could have been added, but I do not believe that is the case). BC
Throttle plate stuck - bound up Manifold tightened unevenly? Throttle plate stuck - bound up Manifold tightened unevenly? Control
Black hard plastic, no white spacer between buttplate and wood of the stock. I happen to have a 1945 Marlin 39A sitting in the safe.
starter motor is mounted into the front of the bell housing this is also where the bolts to secure the starter go if there is a plate between starter and bell housing, it is a spacer to give correct clearance of starter gear and ring gear teeth
it is interference produced from light entering an inclined plate , it is used to measure small distances, the distance can be measured using the equation: (delta) x= lambda/2 alpha Alpha is the angle between the inclined plate and the horizontal surface, x is the distance from the point of contact to the spacer inclining the plate, y is the distance being measured.