It may or may not. As the Weaver mounting system is not standardised, there are variances in the measurements of rails and channels on the Weaver system from different manufacturers. In some cases, Picatinny systems are compatible, and in some cases, they are not.
With enough time and money anything is possible, but, I wouldn't try it.
weaver refers to the type of scope mounts the scope uses. a weaver scope can mount on any rail size.
Scope mounts that mount on the left side of the receiver using the four screw holes are available from Weaver.
Not unless you get the handle adapter and drill a hole in the carry handle.
Its really depending on the length of the rail. The Steyr Mannlicher Scout (my rifle ;P) has really short weaver railing; called Weaver Scope Mounting Rails. The only real thing you would want to put on there is scope rings (to mount scopes) or other sights like iron sights or red dots. Hope this helps.
There are two types of early weaver tip-off mounts, one style had to be mounted to the side of a reciever but had a two piece ring mounting which could be opened to remove or place a scope. The other tip-off is one piece style which fit on a grooved receiver, and was installed at the factory on each scope.Typically these weren't meant to be moved, but can be IF the 3/4" scope has removable turrets. Since these scopes are not sealed nor carry nitrogen, and since they are inexpensive you can do it, just be very careful and clean about undoing the turrets and slide the mount off the front end.
You will have to contact Weaver to find out.
It all depends on the Daisy Scope rings that you have. The M4 has a removable front and rear sight. This will allow you to add a scope to the Weaver rail mount on the M4 if your scope rings are the weaver size. If not, then you need to purchase weaver scope rings for your scope.
Hello: Weaver offers a scope base for the Marlin Model 512 Slugmaster, contact Weaver for a complete package. Thanks side scope mount (Weaver 10M)
weaver marksman 4x
3x
Mount for a scope.