0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Can a 4.0 motor from a 1992 explorer sport bolt up to a 1995 ranger 5 speed manual trans that originally had a 2.3L bolted to it and a if so what else do you have to switch besides the ecm?
change out the bell housing, ECU and motor mounts.. and your good to go
Will a 350 oldsmoble motor bolt up to a 700R TRANS?
yes it will
Where are the speed sensors on a 1995 S-10 2wd pickup truck?
its on the passenger side of the trans, towards the back of it. just take the bolt out and it should pop out.
Will a turbo 350 trans bolt up to a 6.0 liter motor?
NO it will not. Not even close.
Does a 350 1976 Chevy motor bolt to a 1991 Chevy auto trans?
Yes it will.
Will a small block bolt to a 1995 big block trans?
Chevy to Chevy...yes.
Why when you bolt up the auto trans to the 3.8 six the motor the locks up?
is the connector plate the same
Will a 1992 Chevy 427 motor bolt to a 1978 Chevy 350 turbo trans?
No. blocks are not the same.
Will a1989 4cyl 5 speed 4x4 transfer case bolt onto a 2wd trans?
The transfer case will not bolt to a 2wd transmission.
How do you replace a motor mount on a 1995 Chevy Corsica?
You can replace your 1995 Chevy Corsica motor mount by loosening the motor mount retaining bolt. Jack the engine up approximately 3 inches. Remove the motor mount retaining bolt and the motor mount bushing. Put the new motor mount bushing in and reverse the process.
Does a 1974 350 engine bolt up to a 1950 3 speed trans?
probably But why would you want to?
How can you find the hidden bolt to remove the transmission from engine on 1995 lsabre?
four bolts usually in top at back of motor under exhaust crossover pipe one above starter one in back of motor throught the motor and screwed into trans use flashflight, look above pass axle to where the flywheel would be.
