it depends on the engine you want to use some sixes are more economical than some fours
Yes it saves fuel cost it increases octane level and decrease friction in engine
The average cost to clean fuel injectors is about $150. Fuel injectors are used to deliver fuel into an internal combustible engine.
The price of a fuel injector is dependent upon the make and model of the engine. The fuel injector for an automobile engine will cost approximately $35.
cost
The fuel manifold on a diesel engine is a component that distributes fuel from the fuel injection system to the individual fuel injectors. It ensures that each injector receives an adequate supply of fuel at the correct pressure for efficient combustion. The cost of a fuel manifold can vary widely depending on the make and model of the engine, typically ranging from $50 to $500 or more, not including labor costs for installation.
You can change your 1986 305 cubic inch pickup engine from a carburetor to fuel injection. The problem with doing so is the cost. It might cost more to do the change than it would to purchase an engine.
The cost should be between $100-$200. Typically no damage will be done to the vehicle as the engine will stop running before real damage occurs. What will need to be done is the fuel tank will need to be drained and the fuel lines purged. The fuel filter should also be replaced.
It is in the line under the truck about midway to the engine.
a lot you take the fuel price (f) the the actual cost (c) then the delivery cost (d) then the price of the engine (e) then use this formula to work it out: f+c+d+e= actual cost
A rebuilt engine can be bought for about $800. The old engine has to be returned after it is removed from youir car. The new engine has to be installed at a cost of about $2500. Parts attached to the engine may need replacement -- the alternator, the pollution control devices, the fuel injectors, etc. Total cost could run as high as $6000.
In order of cost check: Fuse Fuel pump relay Fuel pump
That completely depends on the type of injector needed and the application(engine)