0
What else can I help you with?
What causes a rotor button to burn up frequently?
To much resistance in the spark plug wires. Start fresh with a new distributor cap, rotor and spark plug wires. Also be sure you have the correct spark plugs installed.
Why would bundling spark plug wires 2 3 and 4 in '91 Mazda B2200 quickly cause them to literally burn up?
cheap wires
Why would the rotor button burn up so fast on 1988 Chevy S-10?
Replace the spark plug wires, to much resistance.
What causes a defective Spark Plug Wire in 1996 Mitsubishi Lancer?
The insides of plug wires are made with carbon. bent to tight or handled ruff will cause the carbon to brake & you have a bad wire. that will cause a miss. Old wires or wires to close to exhaust will cause outside insulation to burn or get hard.
How do you unflood a scooter engine?
The way you unflood a scooter enging is really the same as most engines. First you remove the spark plug. Second, If the spark plug dose hase gas on ether burn it off or find a way to remove the gas for the spak plug cilender.
In legend of Zelda twilight princess how do you get your shield back after it's burnt?
just buy a wooden shield or a hylian shield that wont burn -.-
Why is smoke coming out of exhaust after ignition?
because gas was burn after the spark plug created the spark to burn gas and keep car running.
Why is there burn marks on the outside ceramic on a spark plug on a 1998 F150?
Your spark plugs/wires may be bad or the ceramics may be cracked. Either of these cases would cause a bad connections with the spark plug wires and might cause "jumping" which would cause burn marks along the outside of the spark plug. If your spark plugs appear fine, check the wires for cracks, burn marks, or weardown. Also, and easy way to tell if you DO have a jump somewhere in your spark plugs is to run your car in a dark area and watch for sparks. It should look like a flashlight turning on or off very rapidly. It that doesn't work, (this way is a little more...painful.) Touch the top of your distributor cap lightly, then with more and more pressure, leaving your hand down for longer periods of time until your palm is flush with the cap. If at anytime you feel a jolt or shock, then there is definitely a jump somewhere in your spark/engine array. Doing a minor tuneup may also fix this.If there are burns on your spark plugs, replace them right away and see if the problem persists. (replacing the dist. cap and wires is also a wise decision, and should cost you less than 100 bucks.)AnswerThere are no wires or distributer cap for a 1998 F150 Triton engines
What causes a cylinder to not burn fuel?
No spark.
Can you make mfb bey- blades spark and if you could how?
BY GETTING BURN fireblaze AND spark
Does the distributor on a 1994 Geo Prism have points?
The distributor on a 1994 Geo Prizm does not have points. It's got an electronic ignition system. The ignition coil and module are located inside the distributor. If you're doing any testing of the distributor, be sure to replace the spark plug wires first. Defective spark plug wires will instantly burn out the coil and in some cases, the module too.
Where to get third shield in skyward sword?
actually there are four shields : the wooden shield (will burn and break) this is the first shield they have at the bazaar. once you complete the first dungeon, the iron shield will be available at the bazaar in skyloft (will shock you and break). after that is the sacred shield (will NOT shock or burn and repairs itself) but then there's the Hylian shield that you receive from the thunder dragon you have to redefeat 8 of the 9 bosses and it will never break
