No if you mix Clorox and break fluid it will not cause a explosion. It will only begin to smoke a lot because of the reaction of the chemicals in each product.
Mixing DOT 3 brake fluid with swimming pool shock will not create a bomb. However, it can produce toxic fumes and should never be done as it poses a serious health hazard. It is important to handle chemicals with care and use them only as intended.
Gas is compressible, which means it can compress under pressure and cause the brake pedal to feel spongy and reduce the braking efficiency. Liquids like brake fluid are used in brake systems because they are incompressible, ensuring a consistent and reliable transfer of force from the brake pedal to the brakes.
Adding water rapidly to a hot crucible can cause a violent steam explosion due to the rapid conversion of water into steam. This can lead to splashing of hot material, potential burns, and damage to the crucible and surroundings. It is important to add water slowly to prevent this dangerous situation.
The reaction between brake fluid (typically glycol-based) and chlorine gas is a highly exothermic and potentially dangerous process. When chlorine gas comes into contact with the glycol in the brake fluid, it can lead to the formation of phosgene gas, a highly toxic and corrosive substance. This reaction can occur in situations where brake fluid is exposed to chlorine-based cleaners or disinfectants, leading to the release of harmful gases. It is crucial to avoid such reactions by ensuring that brake fluid is not contaminated with chlorine sources.
Plastic is hard to brake because it is a durable material that is resistant to cracking or breaking under pressure. Its molecular structure gives it flexibility and strength, making it challenging to break or bend easily.
Most times, nothing. This is a confusion of the real question "What happens if I mix Pool Shock and brake fluid?". Answer: smoke and then fire. Clorox and pool shock are both oxidizers - lots of oxygen in it's molecular makeup waiting to combine with something. The difference is that pool shock is 50% - 60% reactive, Clorox is only 4% - 5% reactive. Brake fluid absorbs water from the air. The pool shock reacts with that water creating heat. The heat causes the brake fluid to smoke and if it gets hot enough, it will burst into flame. Note: This is a seriously strong chemical reaction. Fire hazard, burns, smoke inhalation, dangerous chemical waste, etc. can result if you try this. You have been warned!
the blinker switch shorted out the brake lights... really really common problem, need to replace the switch
a brake caliper tool (really)
dnt really no
Mixing DOT 3 brake fluid with swimming pool shock will not create a bomb. However, it can produce toxic fumes and should never be done as it poses a serious health hazard. It is important to handle chemicals with care and use them only as intended.
The purpose of the brake is to stop the bike from moving so it is really hard to move a bike when you put the brake on.
The only thing in an air brake system you'd really overhaul would be the compressor itself... the rest of it typically gets replaced. Valves, brake chambers, brake drums, brake shoes, etc.
Yes, you can get your brake line repaired at Midas, Car X, Firestone, Goodyear which is really good with fixing brake lines and you can also take your car into the dealership.
no its upon the story
No, and it's not really a good method to go about, whether for hydraulic or air brakes. You really need to replace the brake line.
your e brake is on honestly, are you really that stupid?
Really ain't no fixing a brake cable. Replace it with a new cable.