Bass Blocker will not raise the power a speaker can handle. It will keep low frequencies from distorting and damaging smaller speakers that cannot handle low bass.
Yes.
They will work OK. When a speaker is rated at 250 W that is only a maximum and speakers will work will less audio power. Putting two speakers in parallel will double the total audio power output for a given volume setting.
Yes, the sub will work fine. Speakers ususally have two ratings, RMS which is constant power handling and peak power- meaning it can handle peaks of the higher rating. If your speaker is rated for 1300 watts then that is likely the peak rating. It is better to use speakers that are rated for more than the power of the amp you are using so there is no chance of blowing the speakers. The speakers will also produce cleaner sound when the amp is running close to capacity without overdriving and distorting the speaker. Also, if the amp is a stereo amp rated for 1200 watts it is only putting out a maximum of 600 watts per channel.
Manual handling refers yo the use of the human body to lift, lower, carry and empty loads.
They will work OK. When a speaker is rated at 250 W that is only a maximum and speakers will work will less audio power. Putting two speakers in parallel will double the total audio power output for a given volume setting.
Manual handling is the process of picking up, carrying, and putting down objects by people using only their own hands and muscle power. You reduce the risks of manual handling by training people how to safely lift and carry and by providing equipment to eliminate the manual handling of heavy or awkward objects.
Most power amplifiers will handle a load of 6 ohms. The spec you need to look at is the power handling of the speakers. If they are rated for 100 watts program power, then look for an amplifier rated for 100 watts RMS output. Any amplifier can be connected with adapter cables to the typical 1/8" output of your computer.
No. Two 16 ohm speakers connected together are either 32 ohms, if wired in series, or 8 ohms, if wired in parallel. You can, however, connect four 16 ohm speakers in series-parallel to get 16 ohms, with four times the power handling capacity of just one.
You can power two 400W speakers if you have Peavey PV115 using a 2000W power.
Yes, the Kenwood KFC can hold up very well when played very loud. The speakers are a 500-Watt Max Power 5-Way Speaker System that is capable of handling a lot of power.
anything from shoving a blocker to the ground, to kicking the football
Peak power is the highest rated output of the speaker when loud (or peak) parts hit. Continuous/nominal power is the average output at normal and continuous listening levels. If you have the Peak Power rating, you can figure out the nominal level by multiplying the peak power by the square root of two (0.707). Peak Power * 0.707 = Nominal Power.