answersLogoWhite

0

It is not included with the CS6000i, but you can add the Brother SA161 - Adjustable Zipper Foot to your oder. It is designed to work with the CS6000i.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you use button hole maker for brother cs6000i?

To use the buttonhole maker on the Brother CS6000i, first select the buttonhole stitch by turning the stitch selector dial to the designated buttonhole setting. Attach the buttonhole foot (usually marked as "A") to the machine and insert the button into the foot's holder. Position your fabric under the foot, aligning it with the starting point of the buttonhole, and press the foot control to start sewing. The machine will automatically sew the buttonhole in one continuous motion, stopping when finished.


What is the purpose of a zipper foot?

A sewing machine attachment called a zipper foot is made with a longer finger on one side, instead of the usual fabric guide presser foot that has two fingers to hold down the fabric. The single finger is adjustable so you can sew down one side of the zipper, and then move the finger over to sew on the other side of the zipper.


Where can you get nine foot long zippers?

The best advice I can give you is write a letter to a zipper manufacturer such as YKK, JNZipper, or Supreme Zipper Industry


How do you attach a vertical needle zipper foot to a Singer sewing machine?

To do this, you must not only take off your regular presser foot, but take of the part directly above it. You must loosen the presser foot screw, and take everything off below it. Then, look for a part on the zipper foot that hooks around a little. Put that where the original presser foot and the "presser foot holder" was. Then tighten the screw. 1=Loosen the presser foot screw. 2=Remove the presser foot and the part that the presser foot snaps in and out of. 3=Find the hook-like part, the same as on the presser foot holder, and put it where the other one originally was. 4=Tighten the presser foot screw. 5=Put the zipper foot down. It should be a little bit higher than touching the sewing machine. 6=To move the zipper foot from left or right, loosen the screw in the back of the presser foot, and slide the foot from side to side! Then tighten the screw again!


Where did the measurement foot come from?

The name 'foot' says it.


Is Obama close to any of his brother or sistes?

Brother George lives in nine-square-foot hut in Kenya.


What year did 6 foot 7 foot come out?

2011


Where did the foot come from?

the ankle.


How do you change to a zipper foot?

Clip it, Then replace with a New One. "Most can Be found on Ebay or such Sites, If you Relay wanna Change it out I Reccoment using some Tin-Snips, Needle Nose Pliers, Or somthing to Cut it with Stongely You will need to Cut @ Percicely the Right or Left side of the Zipper, {_} <---- Just like this ; ; ; ; + Then Twist to Remove.


Where did foot binding come from?

china


Does a drum foot pedal come with rock band 2?

Yes. (Only if you buy the actual drums, then the foot pedal will come with the drums.)


Is there a Gathering Foot you can use on a Brother sewing machine XL-3027?

For information about the accessories that are available for your machine, contact them at the address shown in your manual. Brother does have a gathering foot, and it probably would fit your machine. There are several sites that have information on this machine. Just type Brother sewing Machine XL-3027