0
yes
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Will the flywheel off a 350 work on a 305?
It will on anything older than 1986. Probably work on the newer ones too.
Can you put your flywheel off your 1981 305 on a 350 without damaging the engine or tranny?
yes
Will a TBI intake off a 350 work on a 305?
Yes it will match and bolt right on with no modifying as long as the 305 was a TBI / Throttle body injection engine from the factory too.
Can you use an alternator off a Chevy 305 on a Chevy 350?
yes
Will an oil pan off a 96 305 vortec fit a 84 350 block?
no
Will heads off a 305 or 283 fit a 350 Chevy?
As long as the 350 is older then a 1987, you will have no problems. They will bolt right on with no modifying.
Will a 400 transmission fit on 305 engine?
It should, but the crossmember is off about 6" from the 350.
You have a 1977 Chevy 350 out of a Chevelle and im puttin it in your 1986 firebird but the fly wheel off of your 305 and bell housing seems to be different what do you do its a 5 spd?
Answer Chevy engines are totally different from Pontiac engines. you'll need an adapter plate to fit it to a Pontiac transmission, assuming you're using the firebird tranny. check www.jegs.com they have the adapter plates there.OK...I don't see where the Pontiac engine comes into play here. In '86 it's a Chevy engine in that Firebird. As far as I know, the flywheel from the 305 will bolt right up to the 350. Use the 305 flywheel, clutch and pressure plate and possibly the starter. Chevy had two different diameter flywheels/flexplates.
How much horsepower can you get out of a Chevy 305 1978?
How much money do you have? The 305 Chevy is not a good starting point. You would be much better off finding a good 350 and work with that small block. The power is only limited by the amount of money you want to spend.
How much horsepower does a 1993 caprice classic 305 have stock?
i'd say about 200..idk where ppl get 170 from off a stock 305 fuel injected..dont under estimate the 305 & to be honest 305's are more durable & last a bit longer than 350's..350's barely have an advantage on 350's on hp & torque but never the less their both chevy's horay lol!
How can you tell a 305 from a 350?
To be sure, take the numbers off of the drivers side rear of engine and check with dealer.
How do you tell a 350 engine from a 305?
if the heads are off the cylinders will smaller than 4 inches in diameter and the stater bolt hole are stright across and on the 350 they are staggered
