0
Will the seat off of a 1985 Honda atc 250R fit a 1984 Honda atc 250R?
Wiki User
∙ 14y ago
No, it will not. 81-84 are the same
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Will the seat off of a 1984 Honda atc 250r fit on a 1981 Honda atc 250r?
no the 81-82 are the same and the 83-84 are the same but they do not interchange.
Will I be able to operate a Kawasaki Ninja 250R safely with prior practices if I am 4'10 and 80lbs?
The Ninja 250R has a seat height of 30.5". It is possible to lower the bike but what you should do is go to a dealership and try sitting on one.
How do you take off a seat on a 1985 Honda rebel?
there should be two bolts behind the passenger seat, take those out. pull the strap on the passenger seat forward and pull the seat back. after you take the passenger seat off you can see the bolts for the front seat, take them off and back the seat out of the lip.
Where is the battery location on a 1984 1200 Honda aspencade?
Under the side cover on The left side of bike just below the seat. Charlie
Is a 2003 Honda 400EX seat the same seat as a 1999 Honda 400EX seat?
it will fit, the graphics might be different
How do you remove the seat on a 1985 honda shadow?
Remove the two Allen bolts at the rear end of the seat with a hex wrench, then slide it back.Loosen the two Allen bolts at the rear end of the seat on both sides. Then you can pull the seat backwards and lift it up a bit. It will be loose.
Where is the reserve switch on a 1985 Honda shadow 700?
The 1983 through to 1985 have a low fuel warning light and no reserve switch. The warning light is hooked to a sensor which is in the secondary fuel tank under the seat.
Were is the spark plug on 1985 Honda aero 50?
center of engine behind frame rail under seat remove black wire with rubber seal and there it is
When was SEAT Sport created?
SEAT Sport was created in 1985.
When was SEAT Málaga created?
SEAT Málaga was created in 1985.
When was SEAT Ibiza created?
SEAT Ibiza was created in 1984.
Why is gas pouring into the air cleaner on a 1984 Honda Prelude?
Assuming it's a carburated engine, the problem is a stuck needle and seat inside the carburetor. If everything else is ok, just remove the top of the carburetor and replace the needle and seat.
