0
Will the valves on a corsa utility get bent if the cambelt cuts?
Wiki User
∙ 14y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Does a corsa b 1.4 16v sport suffer valve damage after the cambelt snapping?
Yes, I have Just had the timing belt snap on mine and some of the valves were bent by the pistons.
What damage is caused by broken cambelt on volkswagen lt35?
bent valves and/or holes in pistons.
What happens when cambelt goes on movano van?
As its a diesel if the cambelt has snapped i would say the head is going to have to come of and you will be needing some new valves as they would of defo bent
Is a Alfa Romeo 156 2001 got a non interference engine?
no it is fully and completely interference, cambelt snap will mean engine rebuild, lots of bent and broken valves and so forth
Daewoo matiz 1999 broken cambelt?
The 800cc engines are NOT non interference engines. I recently bought a matiz with a snapped cambelt. After reading online that it was a safe engine I simply reset the timing and fitted a new cambelt. The car seemed to run fine so I thought I was in the clear. 12 miles later one of the valves snapped and killed the engine, lots! I stripped the engine down after I'd removed it from the car and found that 5 out of 6 valves were bent.
What happens when timing belt breaks on a 2004 dodge neon?
Bent valvesBent valves
What are possible causes for bent valves?
One of the most common reasons for bent valves is a broken timing chain or belt.
What damage am I likely to encounter when a cambelt fails on a peugeot 806 at less than 30MPH.?
severe engine damage, bent valves popped, valve seats, scored piston heads from ring seals breaking up & so on & so on
What causes a bent valve?
The main cause for bent valves is a failure in the timing chain or belt. When the valves and pistons are not exactly in sync, they can collide.
Do you need to have the valves changed when the timing belt breaks?
If the valves bent, then yes.
Can you find out if your pistons hit your valves when the timing belt snaps or do you have to put new timing belt on first?
You can do a cylinder leakage test to check for bent valves.You can do a cylinder leakage test to check for bent valves.
What needs to be done to repair bent valves?
Replace the bent valves and inspect the pistons & head for damage. Replace and repair as necessary any defective parts.
