Want this question answered?
Winding: To wind the coils into the slots on the stator or rotor and connecting them up to form a winding. Re-winding. Is to remove the old winding and doing what I explained above.
In the case of a capacitor-start/run single-phase induction motor, the main field is provided by the main (running) winding, and the capacitive branch is the auxiliary winding. In the case of a capacitor-start motor, the main winding is the running winding and the auxiliary winding is the starting winding.
It is a step up transformer since the secondary windings are greater than the primary. the turns ratio is (primary to secondary) 1:5, so the primary voltages is 1/5 of the secondary (5 volts).
In a single phase electric motor, the centrifugal switch allows the start winding to be energized through the start capacitor when the motor is starting. This gives an out of phase magnetic field that, along with the in phase magnetic field from the run winding, helps the rotor to begin spinning. Once the rotor reaches a certain speed, the centrifugal switch changes state and cuts off the start winding. At that point, the motor continues running only through its run winding, and inertia keeps the rotor properly phase biased relative to the run winding's magnetic field.
The difference between the two transformers is the coil ratios between the primary and secondary windings. A transformer that increases voltage from primary to secondary has more secondary winding turns than primary winding turns and is called a step-up transformer. Conversely, a transformer with fewer secondary windings does just the opposite and is called a step-down transformer.
circumduction
Circumduction. i think im not for sure though.
Injecting power into the higher voltage winding of a transformer will make it act as a step down transformer; injecting power into the lower voltage winding will make it act as a step up transformer. A transformer can be used both ways.
there are three modes of winding up of a company:- 1. winding up by the court i.e., compulsory winding up(sec433 to 483) 2. voluntary winding up (sec. 484 to 521). this may be- (a) members voluntary winding up. (b) creditors voluntary winding up. 3. winding up subject to supervision of court.
A basic, two-winding, transformer consists of two, separate, coils (called windings) wound around a laminated silicon-steel core. The winding connected to the supply (input) is called the primary winding, and the winding supplying the load is called the secondary winding. Alternating current flowing in the primary winding sets up an alternating magnetic field in the core which induces a voltage into the secondary winding. If there are fewer turns in the secondary winding, then the secondary voltage is lower than the primary voltage. If there are more turns in the secondary winding, then the secondary voltage is higher than the primary voltage.
benefit of winding up
it means to liquidation the company that we can do it by three methods winding up by court voluntary winding up and winding up subject to supervition of the court
You Winding Me Up was created on 2010-12-08.
Answer 1Kinetic. Remember, kinetic energy is the energy of movement.Answer 2If one considers winding up for the pitch as analogous to winding up the spring on a crossbow, then you are converting kinetic energy (the motion produced by your arms) to potential "elastic" energy. Releasing the catch on the bow then converts the stored potential energy to the kinetic energy of the bolt as it flies away.Of course people are not crossbows, and the interplay of forces and motions is a bit more complex.Added:Answer two's analogy is flawed as the potential energy on the cross bow winding is not potential until the mechanism is stopped and locked. Until that point the energy is kinetic to potential. A pitcher winding up does not store potential energy as a locked in place cross bow bolt does.Added 2:Hence my statement that winding up a crossbow is *converting* kinetic energy to potential, while releasing the crossbow *converts* potential to kinetic energy.But as already noted, comparing winding up for a pitch to winding up a crossbow is probably not very accurate anyway.When a pitcher winds himself up for a pitch, he positions himself in such a way as to be able to convert the maximum amount of *chemical* energy into kinetic energy. At least, that's how I see it.
For a step-down transformer, its secondary winding will be the LV winding. For a step-up transformer, its primary winding will be its LV winding.
Winding up in the system, winding up dead.
Winding up also refers to liquidation