Lock Smith / Dealer.. Or a Junk Yard.
Lock Smith / Dealer.. Or a Junk Yard.
remove the door panel, window regulator, and window track. lock solenoid should now be accessable You will have to replace the latch, the solenoid is part of the door latch.
The rear window lock on the 2000 Blazer might have gotten rusty and will not turn to unlock the window. Try spraying a lubricant like WD-40 into the door lock. Wait a few minutes and then try the key in the lock.
To take off the interior door panel on Pontiac Montana,remove bolt under door pull (10mm).Remove plastic "scoop" behind handle and lock with flat screwdriver blade.There is another bolt under it. Remove it.Pry up plastic housing for lock and window controls with flat blade screw driver.Remove wiring ( 3 units - mirror, lock and window controls) from housingPry around entire panel with a large screwdiver or prybar,pulling outnylon screws from holes in sheet metal.Lift panel out over handle and lock module, feeding wiring from controls through hole so that panel comes free.Then remove clear plastic from inside of panel to access window mechanism.Now if I just knew how to test window controller or motor to see what's not working.
take off door panel, remove window, remove window sash, unlatch the lock, take the catch pin off, slide out.
The interior panel pops off and there is one screw behind the little panel underneath the strap handle.
First remove your door panel and interior lock module modular with T30 screwdriver. Then proceed to remove the window mechanism and your interior panel. A T20 screwdriver to remove the interior panel and lock module from the inside of door. Disconnect your control module and replace with a new.
remove interior door panel to access power lock mechanism.
check your window lock switch on the drivers door control panel. That is the case with my 1990 works when it wants to.
pull the door off, they have clips you gotta pry..good luck..make sure you get every little screw off first and pop your power widow/lock control off the panel
The manual say's fuse 15 and 23 for a 2000 expedition.
i know you have to pop out the plastic piece on the door grab ,it formed plastic a screwdriver will separate it and there is some screws on the inside.i just replaced my daughters lock assembly,getting the panel off is the easy part.then you have to lower the window down about half way there are some plastic plugs 2 that give you access to the window clamps loosen those and you can pull the window out.also the panel has those pop in plastic hold downs on the perimeter