answersLogoWhite

0

To take off the interior door panel on Pontiac Montana,

  • remove bolt under door pull (10mm).
  • Remove plastic "scoop" behind handle and lock with flat screwdriver blade.
  • There is another bolt under it. Remove it.
  • Pry up plastic housing for lock and window controls with flat blade screw driver.
  • Remove wiring ( 3 units - mirror, lock and window controls) from housing
  • Pry around entire panel with a large screwdiver or prybar,pulling outnylon screws from holes in sheet metal.
  • Lift panel out over handle and lock module, feeding wiring from controls through hole so that panel comes free.
  • Then remove clear plastic from inside of panel to access window mechanism.

Now if I just knew how to test window controller or motor to see what's not working.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Cylinder Torque sequence 2000 Pontiac Montana SV6?

What is the Cylinder Torque sequence 2000 Pontiac Montana 3.4V6


Where is vacuum modulator on a 2000 Pontiac Montana?

The 2000 Pontiac Montana does not have a vacuum modulator installed on it. Instead, it has an electronically controlled transaxle.


How do you change freeze plugs in Pontiac Montana?

where is the freeze plug located in a 2000 pontiac montana mini van


Where is the blwrmtrresistor located on a 2000 Pontiac Montana?

above passenger feet. remove cover, reach as far forward as you can, you will see the connectors.


How do you recharge the air conditioner in a 2000 Pontiac Montana?

No


Refrigerant type in 2000 Pontiac Montana?

r134a


How long does a fuel pump for a 2000 Pontiac Montana last?

my 2000 Montana is still on its original fuel pump


Where are the oxygen sensors located in the 2000 Pontiac Montana?

they are located in the exhaust system Where ? how many 02 sensors on a 2003 Pontiac Montana


How do you remove the wiper switch on 2000 Pontiac Montana?

To remove the wiper switch on a 2000 Pontiac Montana, first disconnect the negative battery cable to ensure safety. Then, remove the steering column cover by unscrewing any screws and gently prying it apart. Disconnect the electrical connector from the wiper switch and remove any screws securing the switch to the column. Finally, pull the wiper switch out and replace it as needed.


What size engine is in a 2000 Pontiac Montana?

its a 3.4 liter


How do I replace a clutch in 2000 Pontiac Montana?

It's an automatic, there is no clutch.


Where is the water pump located on a 2000 Pontiac Montana?

on the front of the engine