0
18 guage will do you ok unless you need to run it a mile or two.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is stronger holding current load a 12 gauge wire or a 14 gauge wire?
The lower gauge number is always a thicker wire which can carry more current.
Can you go from a 14 gauge to 12 gauge wire?
it is not recommended because the 14 gauge wire is not capable of carrying the same amount of load as the 12 gauge wire which could result in a fire.
What size of main and wire if the total load is 50.98amp?
6 gauge
What gauge aluminum wire is needed for 100 amp load?
2 AWG.
What size hot wire do you need for a 1900 watt amp?
A 12 gauge wire can support a load of approximately 2200 watts.
What gauge wire do you need to carry 240 volts 1000 yards?
Wire sizes are governed by the amperage the wire is to carry. To answer this question the load current is required.
What size copper wire between meter base and load center for 200 amp service?
Number 2 American Wire Gauge
What is the difference between 12 2 and 14 2 wire?
14 gauge wire is smaller and is only good for 15amps of load. 12 gauge wire is a little bigger and is good for 20 amps of load, that is best case. there are many other factors that apply such as length of wire run, how long the power is applied, how many conductors are parrellel to each other etc.
What size main breaker do you need to run 10 gauge wire?
The size of the main breaker depends on the maximum current rating of the 10 gauge wire and the load it will be powering. Typically, a 10 gauge wire is rated for a maximum current of 30 amps. Therefore, a 30 amp main breaker would be suitable for running 10 gauge wire. However, it is important to consult local electrical codes and consider the specific load requirements before making a final determination.
How big is 6 gauge wire?
The size of the wire is stated by its gauge under American Wire Gauge. Six gauge wire is size 6 AWG.
Is 8 gauge weld wire fencing stronger than 10 gauge wire?
Wire gauges are defined in such a way that the lower the gauge, the thicker the wire. So, 8 gauge wire is thicker than 10 gauge wire.
What gauge wire should you use for wiring a dock - in conduit - 350 ft at 220 volts?
That depends on the load. In other words how many amps does your load utilize or how many watts? Either figure will work. <<>> Wire size is based on amperage. The higher the load amperage the larger the wire size has to be. In this case also, the wire has to be increased in size to over come the voltage drop for the distance to the load. To receive an answer restate the question with the load amperage or wattage.
