Connect the wiring harness to the back of your 2003 Mitsubishi Lancer CD player. Secure the CD player with the retaining bolts. Connect the ground wire.
Check for a bad ground Im guessing that you connected the new CD player power wire to the illumination wire for the old stereo. Find a power wire that has 12v when the ignition is on.
What it is, is your power ant. wire is hooked to your remote(control) wire of the Amp.To fix this disconnect it and connect it to the remote(control) wire. If you dont have a output labeled as this connect it to the hot wire for the radio. (do not connect it the the constant hot wire there will be two different wires)
You can't connect Wii to the CD player because there is no port for it.
To install an aftermarket CD player the center console needs to be removed. Once removed a after market wire harness will need to be installed so the CD player can function properly. Install the CD player and connect all the wiring.
You "ground" it or connect it to a negative source that is connected got the negative end of the battery
What is dual CD player wire color codes?
You can connect an MP3 to a CD player through the "AUX in" port.
Run your power, ground, and remote wires. Then connect your RCAs to the back of your CD player and your amp, then connect your speakers to the amp..-Shocker
To install an aftermarket CD player in a Toyota Corolla a new wire harness is needed that corresponds with the replacement player. The old radio needs to be removed and the harness will need to connect to the cabin harness. Then the new CD player can be installed.
you cut the yellow and black wire from the origanal plug and wire these from the CD player wire the yellow, red, blue, wire into the yellow and the black from origanal plug to black on CD player
Audio Output Jacks on the back of the CD player