As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.
Before you do any work yourself,
on electrical circuits, equipment or appliances,
always use a test meter to ensure the circuit is, in fact, de-energized.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
You never switch a neutral wire, only hots. hooking both hot and neutral to the same switch will result in a short when the swith is turned on.
No. You can't replace a 220V outlet with a 110/220V outlet without running the requisite neutral wire. If you do you will blow out any device that expects the neutral line to be connected.
The National Electrical Code (US) allows up to thirteen 20 amp receptacles on a 20 amp circuit. 120V x 20A = 2400 VA each duplex receptacle is calculated at 180 VA 2400 / 180 = 13.3333 receptacles, since you can't put a third of a receptacle in, you have to round down to 13.
no
The 20A breaker can handle (25%) more power than the 15A breaker, because of this the wires used inside the walls is larger. Some circuits must be 20A, the laundry and kitchen are examples of 20A circuits.
You never switch a neutral wire, only hots. hooking both hot and neutral to the same switch will result in a short when the swith is turned on.
No. You can't replace a 220V outlet with a 110/220V outlet without running the requisite neutral wire. If you do you will blow out any device that expects the neutral line to be connected.
Need to know what the voltage is. A NEMA number of the pin configuration would also help.
2
The National Electrical Code (US) allows up to thirteen 20 amp receptacles on a 20 amp circuit. 120V x 20A = 2400 VA each duplex receptacle is calculated at 180 VA 2400 / 180 = 13.3333 receptacles, since you can't put a third of a receptacle in, you have to round down to 13.
20a + 45 = 5(4a + 9)
From your description, this sounds like it is a sine wave offset to 10A, so the peak is at 20A, and the min is at 0? For this case, you have 10A DC (RMS) wave and a 10A Peak - neutral AC wave; The RMS value of the AC wave is: 10/2*sqrt(2) = 3.54A. So the RMS amplitude of this wave is 13.54A.
-4(5a-3) = -20a + 12
It cannot be simplified any further, so it is: 5a³ + 15a² + 20a
12
You need a dedicated circuit for that. You cannot power a 220V device off 110V.
It's your wiring, you are putting a Nissan radio into a Toyota so the wiring must be screwed up in there somewhere. The fuse is blowing because a power wire is grounding. recheck the diagrams and correct.