0
Would a 4l60 from a 92 Silverado fit a 91 Silverado?
SammyRamirezfb8838
A 4L60E would not fit on a 91 Silverado because of the different dimensions.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Will the 99 Chevy Tahoe door fit on a 91 Chevy silverado?
yes
Will the suspension out of a 91 c3500 silverado fit into a 93 c3500 chassis?
IT sure will. It is the same.
Will a motor out of a 91 Chevy silverado fit and run in a 98?
No it will not the 1991 is a TBI and the 1998 is a vortec engine. They have 2 different Fuel Injection systems. You would have to change a whole lot of things to make it work.
Will a transmission in a 91 Silverado fit in a 95 Silverado?
Type your answer here... NO. The 95 MUST have the 4L60E transmission put BACK in it if it is a 1/2 ton. If it is a 3/4 ton then it MUST have the 4L80E trans. put in it. If you put the 91 transmission in it then the engine will not run right and the transmission won't shift.
Why wont a 15in crager keystone classic fit my 91 Chevy Silverado 2wd?
Because the wheel will rub / hit the front brake cailbers and rear drums. The 91 was built for 16 inch wheels, are bigger
WOULD a ys1 transmission fit 91 integra ls?
It is a B series transmission. Yes, it will fit.
What tranny is in a 91 silverado 4x4?
It should be a TH700-R4
Where is the oil pressure switch on 91 silverado 350?
The oil pressure on 91 Silverado 350 is at the rear of the engine on the driver's side, This unit is usually found above the oil filter.Ê
31inch tires fit 91 wrangler no lift?
31 inch tires would fit on a 91 Wrangler, but only for casual driving. It would limit your off road capabilities greatly because you will not have the clearance in the fenders.
Will a 89 deville classic grille fit a 91 deville?
No. An 89 classic grille will only fit years 89-90. you would need a classic grille from a 91-93.
Will a 93 mx3 engine fit in a 91 celica?
Any engine will fit in any vehicle, it would just need to be modified to make it fit.
How do you open the hood on your 91 Silverado if the hood latch is broken?
i would probably use a screwdriver to nudge where the latch used to be to pop it open
