answersLogoWhite

0

What else can I help you with?

Related Questions

Are hammerless and external hammer mechanisms interchangeable on similar Crescent Firearms models namely the New Empire double trigger side by side?

Some parts interchange, but most do not.


What is the age of a John M Smyth Co Faultless Goose Gun shotgun with bc575 stamped by the trigger guard?

These were manufactured by Crescent Firearms, c. 1893-1931, for John M Smyth Hardware of Chicago.


Has anyone heard of a Springfield Stevens model 5000 410 double barrel with a single trigger?

I have one. Case hardened receiver, solid rib. Interestingly, in looking a the single trigger, there is a slot next to it (underside of receiver)which contains a piece of metal which does not protrude below the receiver. It's as if it was a double trigger converted to single trigger. I have no idea. It was made before 1948. I use it to this day, got four chuckars just yesterday. It just puzzles me. The side of the receiver says Stevens and next to it "model 5000" and it has an engraving of a pointer on the receiver as well. ????


Where is serial number on Remington mod 12C?

Bottom of receiver in front of trigger


Major Component Groups of the M16 Rifle?

Upper Receiver: Bolt Carrier Group: Gas System Lower receiver: Trigger Group


Where can you find a stock and trigger guard for a Crescent double barrel shotgun?

try gunstocks inc


You were cleaning your 1100 Remington and you accidentally pulled the trigger with the receiver out can this be fixed and if so how?

yes


What are the three basic groups of firearms parts?

upper reciever, lower reciever, trigger mechanism


How does a gun trigger work?

In modern firearms, the trigger allows the firing pin to sharply tap the primer on the cartridge...which, in short, fires the gun. The actual mechanics of the trigger mechanism vary for every weapon.


When did Crescent make J Manton sxs double hammer and trigger 410 shotguns?

@ the turn of the century


How do you install trigger guard on harrington richardson topper shotgun?

Installing trigger guard in H&R Topper 88 single shot shotgun. I am not a professional gunsmith, so your mileage may vary, but this is how I _finally_ got it done. 1. The "trigger extension, the trigger, and the trigger guard have to all line up together, and line up with the pin holes in the receiver when the pin is inserted. It is next to impossible to get them to line up, and keep them lined up. Before in inserted the trigger guard into the receiver, I lined up the trigger, trigger extension, and trigger guard holes. Then I inserted two small splinters of wood from either side as shims and pushed them in tight until the holes stayed lined up. I cut the splinters off even with the outside of the trigger guard. After I inserted the trigger guard in the receiver, I got the trigger guard lined up with the pin hole in the receiver, then I hammered the pin through and drove out the wedges. 2. There are two opposing springs that fit in holes in the trigger guard. The rear one goes to the trigger. The front spring goes to the barrel break release. Leave the front spring out to start. Then after you get the trigger guard back in, you can hold the barrel break release up and drop the front of the trigger guard down just enough to insert the spring through from the front of the receiver.


How to remove bolt from Remington model 514?

To remove: Open action, press trigger rearward and pull bolt entirely from receiver. To install: Insert bolt in receiver, push bolt over plunger in bottom of receiver, pull trigger and complete forward travel of bolt; then rotate bolt handle downward to lock.