0
Would a bad job on replacement a water pump in a 1987 Chrysler Lebaron cause the alternator to blow?
Wiki User
∙ 15y ago
no but they may have broke a wire or disconnected a wire and not hooked it back up
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Would the replacement of the water pump on a 1987 Chrysler Lebaron somehow affect the functioning of the alternator?
no
What kind of safety features would I find on a 2006 Chrysler LeBaron?
The Lebaron was no longer in the lineup for Chryslr in 2006. The Chrysler Lebaron was produced between 1977-1989,and was then phsed out by Chrysler due to weak sales.
How long would it take approximately to replace the timing chain on a 1997 Chrysler lebaron?
The last Chrysler LeBaron was in 1995. Both engines available that year had timing belts.The last Chrysler LeBaron was in 1995. Both engines available that year had timing belts.
What would cause a 1995 Chrysler LeBaron to not have power to the distributor?
There could be a few things on a 1995 Chrysler LeBaron causing the distributor not to have power. But first I would check the spark plugs and see if maybe they have gone bad.
Are 1991 and 1995 Chrysler LeBaron parts interchangeable?
Most would beMost would be
Were is the PCV valve on a 1991 Chrysler Lebaron?
You will find it (the PVC valve) in the same place as you would on a 1995 Lebaron 3.0. I own a 1990 Chrysler lebaron 3.0 v6 and found the PVC valve in the same spot. Look up where to find the PVC valve on a 1995 lebaron 3.0 on this site. Best of luck.
How do release the belt tensioner on Chrysler lebaron?
you have to push down on the tension pulley, then you would get slack in the belt
Why would a 1990 Chrysler LeBaron crank but wont start?
There could be a few reasons why a 1990 Chrysler Lebaron will crank but not start. The fuel pump could be out or the car could be out of gas. There may be a malfunction in the ignition system causing no spark.
How do you replace the alternator on a 98 Chrysler Concorde?
There are three main steps behind replacing the alternator on the 1998 Chrysler Concorde. The first is disconnecting the battery cables for safety. Second, is depressing the belt tensioner to allow for the release of the drive belt. Finally the alternator can be unbolted from its bracket for replacement. If the drive belt, idler pulley and tensioner are worn it would be an ideal time to replace this components as part of the install.
What would cause the parking brake to stick on for a 95 Chrysler lebaron?
it seizes thru lack of use... overhall it..
Is the rear quarter window mechanism the same in the Chrysler lebaron coupe and the convertible?
Knowing the way Chrysler often interchanges parts from many different cars, I would assume it would be about the same.
Why does my 1993 Chrysler lebaron shake at 35mph?
I have the same issue. I would look at the over drive sensor/module as the culprit
