0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
The force with which gavity attracts a body?
That would be the Gravitational Force.
Is Pressure force per unit of mass?
you would use newtons (N) 100 grams of force=1N It would be force per unit area.
On a wheel and axle where would you apply force to make a greater force?
Probably on the axle??
What is maximal applied force?
That would be a force that is applied at maximum power.
What is An unbalanced force acting on an object?
the unbalanced force would be balance.
What are some free online games not blocked by the military?
Some free online games not blocked by the military include Strikeforce Heroes and City Siege. You can also play Air Gunners for free.
What is the nickname of Pinatubo?
Blocked force
What would cause the coolant to boil in my 1996 Saturn?
1) Bad water pump 2) Bad thermostat 3) Clogged radiator 4) Clogged fins of the radiator and/or AC condensor, blocking the air flow. 5) Broken cast extension nub that hold the thermostat's end pin. If this is broke then the coolant flow force the thermostat to stay closed (the stat needs that little nub to push off against). 6) Defective cooling fan (if you have AC turn it on; this will force the fan to operate, verifying it's operation). 7) Defective temperature sensor. If the coolant is forcing it's way out the recovery bottle's cap then you most likely have a thermostat problem. If the stat will not open (for what ever reason) the pressure created by the water pump will force it past the cap. This also ruins the cap requiring it's replacement as well. If the aforementioned nub is broken you will have to go to Saturn for a replacement, but the Saturn unit will come with a new thermostat.
Where is the thermostat located on a 1993 buick century limited?
If this has a V6 engine, it is behind the thermostat housing. Follow the upper radiator hose to the engine end at the intake manifold. That is the thermostat housing. Remove the two bolts and poke the thermostat with your finger for fun. If this is a 2.5L engine, it is inside the thermostat housing, which has a cap on it. This is located at the engine end of the upper radiator hose. Let the engine fully cool, then turn the cap counterclockwise, which may require a lot of force. Use pliers to twist the thermostat handle (in either direction) and pull it straight up and out. If it's old, the handle may snap off which means long-nose (needle nose) pliers will be required to reach down to the thermostat and remove it. If the cap was difficult to remove, get a new cap.
1994 Pontiac Sunbird 2.0 engine When the car is warming up it has heat but after you drive it for mile you lose heat and it blow cold air have replaced the water pump and thermostat?
You will need to change your thermostat, as it is been stuck open. The thermostat is the piece that control the quantity of cooling fluid that goes to the radiator, if its stuck open all your fluid is going to be cooled by ambiant air on the radiator, and the engine will get colder then its operating temperature. If it close properly it will force the coolant to be cooled by the heater radiator, which transfer the heat to the air in your heater system. The piece itself is like 10$ or less, but the installation can be tricky if your not mechanicly inclined.
Where is the thermostat located on a 1990 Buick LeSabre Custom?
follow the upper hose from the radiator to the engine and where it clamps should be the thermostat housing assembly... also, you should be able to find a shop manual at the library, you'll have to make copies of the sections you want as they are reference only, but everyone should have a regualar manual for their vehicle, available at an auto parts store....may the force be with you :)
Why is your heater blowing out cold air when your engines temp is warm?
I had the same problem with mine. It was the thermostat, it was sticking and would not open until the engine got very warm and would force the thermostat to pop open, then the car would fill with warm air until the engine got back within operating temps or cooler, then it would stick shut again.
Can't fit thermostat in housing 02 Nissan altima do you have to force rubber seal down?
No it should fit into the housing along with the thermostat. Try putting the rubber in first, then the thermostat. remember the rubber is malliable so it will conform to the opening, then insert the thermostat
What is the material that repels gravitational force?
There is no known material that can completely repel gravitational force. Gravitational force affects all matter and is a fundamental force of nature that cannot be blocked or neutralized by any material substance.
What can cause the radiator water to leak from the top of the reservoir tank?
It might be a bad thermostat, or something worse, such as a blown head gasket/cracked head. Either of those scenarios will cause the cooling system to pressurized beyond it's specified capacity, and the pressure will force the coolant out of the reservoir.
What could cause fluid to be forced out of coolant reservoir?
many people will tell you many diffrent causes. such as a blown head gasket,bad thermostat,and bad water pump. but i will say its a trapped air bubble. if for any reason your radiator or resivoir has went down air got into your system. take cap off resv. start car and turn heat on..let it run for 15 minutes. after 15 minutes squeeze and hold for about 10 seconds the top radiator hose that runs from the radiator to the thermostat houseing. it will be hot if thermostat is working so use a rag or towel...this should force air bubble out....you may need to repeat this several times over a couple of days. once done be sure to add coolant because after air exits it will drop some.
Can you shield a magnet?
Yes. Magnetic force can be blocked by shielding material such as steel, aluminum or any good conductor.
