answersLogoWhite

0


Best Answer

If the Gauges on your instrument panel have stopped working you may have had a voltage converter stop working. This device mounted to the rear of your instrument panel converts the voltage from your alternator to the voltage that your gauges run off of. You can check the fuses with a multimeter and see if both sides have voltage showing, if so then see about replacing the voltage converter.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Would a cancel switch make the gauges on your 1987 samurai stop working?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Dash lights to gauges no working?

The dash light brightness control may be turned off, check the switch.


How do you bypass the ignition switch in Mazda Protege?

2002 mazda ,,gauges are still working after taking out key..any ideas


Why on a 2003 Chevrolet Malibu would the radio heater and gauges work intermittently?

It sounds as if you have a defective ignition switch. The next time it happens you need to turn the key slightly. If it starts working then the ignition switch is bad.


Why does headlights stay on with Suzuki Samurai?

try a switch


I don't have any dash lights or gauges working What do I need to do for a Jeep Comanche?

I had a 1986 cj that had the same problem. Couldn't find the problem until the dimmer switch on the floorboard went out. Replaced the switch and the gauge lights started to work.


Where is the overdrive cancel switch on 2008 Toyota 4runner v8 limited located?

There is no "switch". To cancel overdrive move the gear lever from "D" to "4".


Why S10 gauges go out starter will not work?

check your ignition switch.


Where can you buy a blower motor switch for an 1987 Suzuki Samurai?

Suzukijohn.com


What would cause the cruise control to stop working the light on the dash ison?

Check your tail lights. If they are stuck on the switch might be bad. The brake switch will cancel the cruise. If a light has a ground fault the voltage will feed back and cancel the cruise. Those are a couple places to start looking. If that's not it, it's probably a little more severe.


Why does the gauges on a F150 still come on with no key in ignition switch?

Posible relay problem


Where is the ac high pressure cutoff switch located at on a 1988 suzuki samurai?

it does not have a high pressure switch all it has is a evaporator temp sensor/switch.


Why gauges and speedometer lights won't lit?

have you checked the fuse? is the dimmer switch turned down? have they just quit working? Headlights/taillights work? Interior light? Need more info!! What have you checked so far?