It could.
It sounds like the low beam/high beam switch is bad. Fuses are not the problem since they are built into the headlight switch and would cause headlights to blink or not come on for both high and low beam headlights.
How absorption and scattering can affect a beam of light is if the beam of light is farther away from an object, the light would be dimmer. But, if the beam of light was closer to the object, then the light would appear brighter.
How absorption and scattering can affect a beam of light is if the beam of light is farther away from an object, the light would be dimmer. But, if the beam of light was closer to the object, then the light would appear brighter.
bad ground in high beam switch
You can check the ground in the wiring if nothing else works. However, it would also be a good idea to see if you are just making a simple mistake. Sometimes the light-on switch is separate from the hi-beam/lo-beam switch; try pulling back on the turn signal lever while the light is on. It should switch between hi and lo beam.
It is on the signal light switch. Pulling it toward you will change from High to Low beam lights and vice-versa 7T77T7
It is the combination turn signal, high beam, head light switch.
The headlight high/low beam dimmer switch is part of the turn signal switch.The dash light dimmer is next to the headlight on/off switch.The headlight high/low beam dimmer switch is part of the turn signal switch.The dash light dimmer is next to the headlight on/off switch.
A neutron star that "blinks on and off" is called a pulsar. They don't really blink, but there is a jet or jets of energy that come off some of these stars. Think of a light house. You see the beam "blink" but it's just that the beam crosses your line of sight.
A short in either the multifunction turn signal switch or a short in the wiring harness going to the switch.
the switch for turning your lights on ie parking - low beam,pull it out for interior light dude....
Normally the blinking on and off indicates there is a broken switch, broken wire, or a piece of bare wire. First, I would test the switches.