0
What else can I help you with?
Why is the water in my sight glass for my sand filter milky blue?
It is probable that the glass is plastic and has been tainted by one of the chemicals that you have used in the pool. have you used any metal based algaecide for instance
What are the white suds on the pool water?
Without seeing your water, I am going to guess that the liquid algaecide you are using is a quat (quatenary ammonium). It is an effective algaecide but it can cause the water to get a little "sudsy" or "foamy". You may have had just a bit too much in there. A way the old service company guys would check your algaecide level was to put their hand in the pool and shake it around. If it foamed some, then you had enough. Usually a good shock will clear that up.
Why would your 03 dodge caravan have milky oil but drives great?
Milky oil is water or coolant in the oil. You need to find the cause and fix it. Causes include head and intake gaskets.
Is it safe to swim after using algaecide treatments?
Its never done me any harm. However follow the directions on the container of the algaecide, if it tels you not to swim in the water for a period of time after treatment I would head their advice.
What can cause Green water in spa?
Sound like you have a problem with algae. An algaecide can be purchased at a pool shop to fix this problem. Just in case take a sample of the water with you when you go.
Is algaecide added to slat water pool when filter is on?
Adding algaecide to the pool when the filter is on should not do any harm in fact it should mix it into the water more quickly
Can you swim in a pool that has foam in it?
Suppose you could but who would want to. You possibly have added too much algaecide. Have a dirty filter. Have poor chemistry - out of balance chemically. Too many people in pool. Lack of proper filtration.
Would a blown timing cover gasket cause the oil to turn green and milky?
you have a blown head gasket water is getting in to the engine oil
Would it take more time or less time for the lime water to turn milky while sleeping?
Sleeping would have no effect on the time it would take for lime water to turn milky.
Can you heat a pool after using copper algaecide?
Yes, you can heat a pool after using copper algaecide, but it’s advisable to wait at least 24 hours to allow the algaecide to disperse and bind properly. Heating the water immediately after application may reduce the effectiveness of the algaecide. Always follow the manufacturer's instructions for optimal results.
What do you do about too much algaecide in a pool?
Typically, no. If you have alage and are using an algaecide to help clear the water, then the chlorine is also being used up killing alage and the decaying dead algae cells in the water. If you don't have algae and are using an alagecide as a preventative measure, then the algaecide will slowly breakdown on its own. But it will not use up the chlorine. Hope this helps ... check the cyanaric acid level of the water, you may have low or no stabelizer in the water, this will mask the chlorine reading. you may have a good level of chlorine but is being masked by lack of stableizer. hope this is of help, enjoy the season.
Can milky water kill fish?
Milky water should tell you its time for a water change!
