Want this question answered?
The rocker arms are not torqued to a specific setting. Follow the instructions in any repair manual for the proper method for adjusting backlash.
The torque specifications fourth the rocker arms, on your C 15 Caterpillar diesel engine, is 14 pounds per square inch. The rocker arm should be torqued at seven pound intervals.
No, they are torqued to a specific amount and the lifter controls lash.No, they are torqued to a specific amount and the lifter controls lash.
You don't. The nuts that hold down the rocker arms are torqued down to specs and that's it. There is no adjustment. If you have valve train noise you probably have worn valve train parts.
well the lifters shouldn't be too tight if they are the correct lifters for your vehicle. if your having problems with your valves opening its probably because your rocker arms are torqued beyond specifications. buy a manual and loosen your rocker arms torquing to specs.
The 2000 Chevy Impala 3.4 liter engine rocker arm bolt torque specification is 45 pounds. The rocker arm bolts should be torqued in 15 pound intervals.
Not usually. If the rocker arms are loose because the cam lobes are worn down, that could be an indication of a worn engine, which might have bad rings or loose valve guides, which would cause an engine to smoke.
Yes they can depending on which ratio rocker arms you get.
to adjust the rocker arms you have to either tighten or loosen the top bolt on the rocker arm/arms that need to be adjusted. there is a specified torque for the rocker arms that you should follow to help you adjust the them
The valve lash is not adjustable on that engine. The rocker arms are bolted down and torqued to specs. If you have valve clatter you have worn valve train parts.
worn, lose rocker arms
what is the torque on 2.2 rocker arms and in what order