Best Answer

Yes BUT you need a set of maxima caliper brackets..

User Avatar

Wiki User

โˆ™ 2012-07-12 22:02:42
This answer is:
User Avatar
Study guides

Create a Study Guide

Add your answer:

Earn +20 pts
Q: Would rear disc brakes from a 1982 280ZX bolt onto a 1974 260Z that has rear drum brakes?
Write your answer...
Related questions

Can a Nissan 1981 280zx hood fit on a 1982 280zx?


What is the idle speed for 1982 Datsun 280zx automatic?

My 82 280zx turbo shows 650rpm on the decal under the hood...

Did all 1982 280zx come with four seats?

No, all 1982 Datsun 280zx are not 4 seaters. Those are known as 2+2 models. The 2 seaters are known as coupes.

Where do you find the temp sensor on a 1982 280zx?

below the thmostate housing.

Will a fender from a 1980 280zx fit a 1981 280zx 2 2?

Yes, nothing really changed bodywise until the 1982 model year.

Where is water pump of Datsun 1982 280zx?

On the front of the engine behind/attached to the fan

Will a 1982 280zx tranny fit in a 1981 280zx?

Yes it will. Also if you have the 5-speed (borg-warner t-5), you can also use one out of an 80s Camero or foxbody Mustang.

Can you show me a vacuums diagram for a 1982 280zx turbo?

I do have purchased my 82 280zx Non-Turbo and would like to get all the hoses on the engine completely new. I do have some areas where the hoses are missing or have been caped. I would like to know the exact locations on where they should go. I thank you ahead for your answers. Eman

How many gallons will a 1982 Datsun 280zx hold?

21-1/8 gal or 80 L

What is the Value of very clean 1982 Datsun 280zx?

could possibly be around $40,000 if there is zero rust

When you try to start your 1982 Datsun 280zx it will not start it has fuel pressure and inginition is firing?

prob a vacume leak

Where can you find a T-top for a 1983 Datsun 280zx?

I have one out of a 1982 do you need left or right? I have a parts car

Did 1982 280zx's originally come with louvers?

i think so, mine has them and the original owner said he got it from the dealership like that

Where is the spare tire on a 1982 Datsun 280zx?

It should be located behind the right side panel of the trunk, along with a jack

What is the firing order for a 1982 Nissan 280zx?

Firing Order of Nissan's L-6The firing order of the 1982 is 1-5-3-6-2-4 (1982 Datsun 280ZX Service Manual, October 1981 edition), all L24-L28E engines use the same order (240Z-280ZX till 1983). In 1984 Nissan changed to the VG30E for the 300ZX which has a firing orde of 1-2-3-4-5-6.

What is the vacuum hose diagram on a 1983 280zx Datsun?

Try going to the following website: Click on Service Manuals "Cars" and you can then download a free copy of the 1982 280zx manual. A picture might be better; but, a diagram can be found in the EF & EC (engine fuel and emmissions) section. 1982 & 1983 should be the same.

What are the release dates for Midnight Blue - 1974 1982-10-04?

Midnight Blue - 1974 1982-10-04 was released on: USA: 4 October 1982

What are the release dates for Midnight Blue - 1974 - 1982-10-04?

Midnight Blue - 1974 - 1982-10-04 was released on: USA: 4 October 1982

Where is the fuel pump on a 1982 Datsun 280zx located?

I believe it is in the rear driver side of your car. When you turn your key to the on position you should hear it "kick in."

How do you remove and install upper and lower speedometer cables on a 1982 Datsun 280zx?

pull the dash apart. behind the speedometer you will see the cable. it connects to the transmission.

How do you check the mass airflow sensor on 1982 280zx?

Reassure the resistor of the hot wire anenmeter to determine if it has failed. This can be done at the same time that you test the oxygen sensor.

Who was the us Wimbledon champion in 1974 and 1982?

Jimmy Connors

What are the release dates for Melissa - 1974?

Melissa - 1974 was released on: UK: 4 December 1974 USA: 30 November 1982

Did any 1979 Corvette come factory with 4 wheel disc brakes?

All C3 Corvettes (1968 - 1982) came with factory 4 wheel disc brakes.

How do you change the starter for a 1982 280ZX?

remove wires from the top of starter, remove the two bolts that attach starter to bell housing, pull starter off, reverse to put starter back on