first check your fuses and fuel relays make your power to the pump. check the fuel reset swich. i good manual would be a good start..
Carpenter ants dig through wood leaving a sawdust residue. Wood bees or carpenter bees also leave a sawdust residue as they dig into wood to make a nest. Termites actually eat the wood so they would not leave a sawdust residue
Hydrogen has the highest calorific value, which should make it good fuel
If the fuel is running too rich in a car, it would be a good idea to adjust the EFI or Electronic Fuel Injector (carburetor). It would also be a good idea to make sure that all of the air cleaners and oxygen sensors are clean and functioning properly.
http://www.fuelpumps.com/ would be a good place to start. They offer fuel for the certain make of your vehicle model. Fuel Pumps is the world's leader in performance and OEM replacement fuel pumps and accessories.
They make fuel efficant cars
MIght be the injector itself.
it is different on most vehicles. so the make and model would be needed. have a good one!
First make sure the fuse to the fuel pump is good then pull the fuel supply line to the carb and turn the key on and see if fuel pumps out (note: make sure you have a bucket the catch the fuel.) If fuel pumps out, the fuel pump is fine, if not than it may be bad.
For any vehicle to start the vehicle needs three things fuel(and air), spark, and compression. If I were to look at the vehicle I would first check for spark. I would remove the spark plug wire and attach a test plug to see if the ignition is capable of firing. If that checked ok I would pull a couple of plugs to see if they looked ok and would make sure there was no fuel on the plugs. If that proved ok the next step would be to hook up a fuel pressure gauge and make sure I had proper fuel pressure. At this time I would also take a fuel sample and make sure the fuel was not contaiminated. If I had proper fuel pressure and good spark the next step would be to make sure the fuel injectors were getting a pulse from the computer. Lastly, if I had good spark,fuel pressure(including good fuel),fuel injectors were opening I would check the valve timing to make sure that was correct. Your problem will be with one of those items not working properly once that has been determined narrowing down the exact cause will become alot easier. Hope this helps, Brandon
Well they had this idea to make fuel out of algae but they are working on it . :)
Check the electrical connections going to the pump, including checking to make sure the ground is good.