answersLogoWhite

0

This will not effect the engine in any way

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Which hose is the inlet to a heater core on a 350 Chevy engine?

The outlet from the 350 engine to feed the heater core would be the one closest to the thermostat.


Where is Engine block heater 2010 Ford Edge?

A block heater for that vehicle would be an option. If it came equipped with a block heater the cord would be found close to the battery.


Can driving with no coolant cause heater core to go out?

It can do far worse, such as destroy your engine block. I wouldn't worry about your heater core, I would worry about your Engine.


Why would a car heater be blowing cold air?

AnswerBad thermostat, clogged heater core, or a defective heater control switch. If an engine has not been running long it will not have warmed up, the warmth from a car heater usually comes from the engine.


Would bypassing the heater core hoses on a 92 Taurus be safe for the engine?

This Would Not Allow Heat Inside The Car. And Would Not Damage The Engine. If You Bypass The Heater Core You Have No Heat. The Heat Comes From Yhe Water Flowing Through It From The Engine. Its Winter Try To Have The Heater Core Repaired Or Replaced. the heater core is the only thing that provides heat to the inside of your car so bypassing it would leave you cold but it will not hurt the engine as long as you couple the two hoses together


Why would a car heater blow cold air but when it's moving it blows hot air?

check heater core could be cloggedCheck the engine coolant level also.*no, the heater relies on the engine for heat and when you drive the engine warms generating heat:)*


Why would engine run 195 degrees but heater not get hot?

Plugged heater core. Faulty temp blend door mechanism.


Where is heater cord in 2010 mazada tribute?

first, an engine heater has to have been installed on the vehicle. if the car did have an engine heater installed in it, most newer vehicles would have had a soft plug heater put in. soft plugs are located on the side of the engine block. they knock that plug out and install a heater in it. look for any ac wire( it will look like a three prong plug on any of your household appliances) in the engine compartment.


What would cause a car to lose heat?

Your heater is powered by your heater core. Your engine coolant runs through your engine gets hot, runs through the core heats the air, then back out to radiator. You probably need to replace your heater core.


How many watts is a block heather?

A typical block heater for a car engine would be around 400-1500 watts, depending on the size and efficiency of the heater. This kind of heater is used to keep the engine warm in cold weather for easier start-ups.


What does a block heater do for your car?

A block heater is a device one would use to heat the engine of a car in extremely cold weather. The block heater can be mains generated or will run on the fuel source of your vehicle.


Where is the block heater in a 1993 Mercury Topaz?

If you have one installed, on the 2.3 L engine, it would be in the back of the engine, looking at the engine from the front of the car. Its in the frost plug.