0
What else can I help you with?
How much money would you get if you turned in your Nintendo ds lite at disc replay?
they will give you about $25 for a lite and $30 for a dsi
Who turned on refrigerator lite?
Michael Jackson...
What is wrong if your pilot light will not stay lite?
High winds, pilot generator. Is the heater located next to a wall? Is the heater door closed? Does the heater have a draft hood or what they call a stackless heater? Ken
What do you do when your ds lite gets water on it?
get a new ds lite
Dash lights do not lite up?
my g6 heater and shifter console does not light up
Pool heater pilot on burner won't lite?
it's most likely a water flow problem....check the pump filter and clean if necessary. this happened to ours yesterday, and today we found the filter was clogged, cleaned it, and the heater started right up.
Can a Laars Lite 2 heater for a chlorine pool be used if you convert to salt water?
Yes, a Laars Lite 2 heater can be used with a saltwater pool, but it's important to ensure that it is compatible with saltwater systems. Saltwater can be more corrosive than traditional chlorine, so you should check for any specific guidelines or recommendations from the manufacturer regarding saltwater use. Regular maintenance and monitoring of the heater's condition are also advisable to prevent potential corrosion issues.
Have a laars lite 2 pool heater and cannnot get pilot to even lite you hear gas bleeding but it will not lite?
Good chance its your hot surface ignighter that has broken. Check to make sure that there is 120 v or far more common 220v at fenwal Depending if heater is wired for 120v or 240v. If proper voltage is present ignighter is broken. by zoomy
What other problem besides the thermocouple would cause a heater not to stay lite?
The thermocouple only keeps the pilot light. Temp sensor,gas valve, high limit switch, safety switch,thermostat, would cause burner not to stay lite. Better to post MFG,model, problem. lenox,model #, ______________________________
Where is the overheat switch on a lars lite 2 pool heater?
The overheat switch on a Lars Lite 2 pool heater is typically located near the heat exchanger or control panel. It is designed to automatically shut off the heater if it detects excessively high temperatures. For precise location, refer to the owner's manual or the heater's schematic diagram, as placement may vary slightly between models. Always ensure the heater is powered off before attempting to access internal components.
How much does a lite of water weigh?
a litre
How long does the DS Lite's battery last while turned off before it resets clock and preferences?
Never!
