Yes, it will work on your CTS. No additional fees for this model and you will be able to use your remote door lock and unlock.
Your remote's model is actually PMDVD6. You should be able to get the manual for this remote from Philips' website.
im guessing that your talking about the alarm/keyless remote. You will find that you have to get closer and closer to the car to be able to unlock it. You should replace the battery when you have to be within about 10ft from the car.
The Sky Plus remote gives you the additional features of being able to stop, fast forward, rewind, play, and pause the programs that you watch. It also has all of the normal features of a regular Sky remote.
You should be able to get in the Explorer , lock the doors if you wish , and then start the vehicle . That's what I do on my 1995 Explorer XLT
you can go to the dealer with the radio or the VIN # and the should either be able to unlock it for you or look up the code.
You can try to call the dealer and tell them your situation, they should be able to help
Well, if you aren't stealing the car you call the dealership and tell them what model it is and the year. They will be able to sell you a key/remote or tell you to get a locksmith and drive into them so they can replace the lock. This will cost you a few dollars.
Is the key fob on the remote not activating it, or is it that you can't open the swing gate manually? The remote batteries might be shot, if it's not working, or the electric actuator to unlock the door might be bad or loose wiring. The rear window is all that is suppose to actually pop open when you hit the remote, then the swing gate is supposed tp unlock automatically, not pop open also. Hard to tell what's wrong with the vague question? Give us more details, and maybe someone will be able to better help you. Good Luck.
maybe becuz if super sonic is unlock able then shadow and super shadow should be unlock able
you can unlock vegeta ss3 by doing a unlock able mode in dragon ball raging blast the game
This will work on new remotes you just purchased or on old remotes that you may have had batteries replaced that lost program. It must be followed exactly. First, hold down the unlock button on your door and keep it held down. While holding down, turn ignition key on (two clicks) and off two times (dont start vehicle). The speed at which you do this is not important, but just turn to where the radio will play and the instrument panel lights up. After you have done this the unlock-lock will cycle on your doors automatically and the horn will sound. Now, you can let go of the unlock button on door. Next hold the Lock and Unlock buttons on the remote, both at same time for 15 to 20 seconds, until your doors cycle thru lock-unlock. They will do this automatically while you are holding both remote buttons. If you have more than one remote repeat the last step for each remote in succession. On a 2004 Tahoe you can have up to four remotes programmed. Now, Turn the key on again and then off. The locks should cycle and the horn will sound. This should set your remote to work. If this does not work, there may be a problem with the remote or you may have a remote not compatible with vehicle or even dead battery in remote. Many remotes look identical, but will not work unless they have the correct ID number. If you have simply replaced the battery in your remote you should be able to resynchronize the remote without reprogramming all remotes. This is in your owner's manual and is done by standing close to your vehicle and holding both the lock and unlock buttons for 15 to 20 seconds. The door locks should cycle and there you go!
Sorry there is no unlock-able like that.