the shift cable attaches to the top of the column down near the brake pedal area. It has probably come out of it's holder bracket.
GO BACK and check your work, something was left disconnected. good luck, Jamison
The ignition switch on a 1995 Mazda pickup is changed by partially removing the steering column to reveal the switch on the side of the column. It can then be unbolted from its mounts, the wires disconnected, and a new switch put in place.
There are 4 bolts at the bottom of the steering column that tend to get loose after entering and exiting your vehicle. Pulling your self up on the steering wheel puts stress the steering column and causes it to become loose. If you do not correct the problem fast by tightening the bolts you will have to replace the entire steering column.. -Henry's locksmith and steering column repair
The steering column.The steering column.
Ignition switch should be connected to a rod that runs down the steering column to the actual switch at the lower end of the column. Check to see if this rod has become disconnected or broken
The steering wheel is mounted on the steering column.
The steering column is the part the steering wheel sits on.
The steering column is the part the steering wheel is mounted on.
A steering column is found in a vehicle. It is the column to which the steering wheel is attached, and commonly also provides attachments for indicators. The ignition key is also often found on the steering column.
Yes, the only difference is the steering ratio, which can be changed.
The steering column has to be replaced. The steering column has to be replaced.
its in the steering column its in the steering column