Want this question answered?
yes. a friend of mine has her tubes clamped and she ended up pregnant and had a son
Can i get pregnant if my tubes were clamped?
Just follow the BOTTOM radiator hose to were it clamps onto a housing on the front of the engine and it will be behind the housing that the hose is clamped to.
The hose fits over the male end of the inlets and outlets, and is clamped in place with hose clamps.
Follow the top radiator hose from the radiator to where it clamps at the engine. The hose is clamped to the thermostat housing, the thermostat is under the housing.
If 5 days late is unusual for you, you should take a pregnancy test. Tube clamps have been know to open.
Yes it is possible. Having clamps and then having the procedure reversed leads to excellent healthy fallopian tube lengths. This is one of the best tubal ligation methods to reverse.
I would think since the tube is not blocked anymore that you could get pregnant I have my tube clamped to and I was wondering how do you know that the clamps fell off is there any pain associated with it? Well I was told yesterday that my clamps have fallen off and yes I can get pregnant so this is something to be careful about if you are not wanting another pregnancy and also I have felt no pain or discomfort at all. To be honest I had no idea they had fallen off.
Depending on the problem. Usual issues are leaks. Find leak & repair as needed. Return line is neophrene and low pressure - can be secured with clamps. High pressure side has crimped ends (no clamps) on rubber section going to steel section and is usually replaced as an assembly. Can be patched with HIGH PRESSURE hose and double clamped with fuel injection clamps but you're asking for problems down the road.
Stamps Lamps Clamps Ramps
I cut off the rusted out lines with a small tubing cutter and replaced them with regular heater hose and clamped the ends. Copper tubing and hose clamps also work.
Raise the vehicle to give yourself more room, the filter is located on the passenger side of the car right before you get to the back tire. Its clamped on using 2 clamps, just a simple screw driver can remove the clamps and the pump is held on the car using 1 bolt that is 1/2 Inch... real simple to do, shouldn't take you more then 5-10 minutes to complete.