Removing Front & Rear Rotors Well Guys...
I remove my Front & Rear Rotors out of my 1998 Ford Expedition XLT.
I rented a 3 Jaw Puller from Auto Zone and a bottle of PB Blaster and a sledge hammer it only took about one hour or less to take both off...
The way I removed the Front & Rear Rotors was ...
1. I put lots of PB Blaster in the back and the front of the rotors to be removed.
2. I put plenty of tension with the 3 Jaw Puller...
3. I hit the back of the rotor with the sledge hammer...
And it came right off...
Hope this helps someone out there...
Which fan are you refering too? cooling fanHeater fan
Change the front turn signal light bulb. It's bad.
the four wheel drive is opperated by vacuum that's probably where your problem is
remove the tire and brakes then pull them off if they wont come off use a hammer or mallet and that should free them up
you need a new bulb in right front.
No.
i know that it will come out one most of those and ps2
wont start
if you're asking "why wont they come off".........there is an inner retaining ring that has to be removed. behind the hub assembly that is. its hard to see with all the grease and is a pain to remove. I used two small picks or screwdrivers. I hope that's what you meant.
no it wont fit.
Check fuses and light bulbs
I Definitely wont like my female family members to come in front of her and because of being a man i might think her as an alien