0
You just replaced a vacuum hose on your 97 Monte Carlo and now your car RPM goes up and down on its own Whats wrong with your car?
Skceo
Sounds like there is a vacuum leak somewhere, go back and check all of the fittings to verify they seal
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Whats the bolt pattern for 99 Monte Carlo?
The bolt pattern for the 1999 Chevrolet Monte Carlo is 5x115. This is the same pattern that is used on the Uplander and the Lumina.
Problem with electric door locks with 1999 Monte Carlo?
whats the problem?
How do you change water pump on 2006 ss Monte Carlo?
whats the eigine size
What type of oil do you use for your 2002 Monte Carlo?
5w30 is whats recommended from the factory.
1994 3.1 Monte Carlo leaks coolant from rear of intake manifold area whats leaking?
I would suspect the manifold itself is leaking around the cooling passages. It will need to be removed and the gasket replaced.
Would you rather have a 76 Monte Carlo or 64 mustang whats worth more?
Mustang all day
Where is the crank sensor on the 1995 Chevrolet Monte Carlo?
whats wrong my starter wire caaame off how do i put it back on
Whats the rim and tire specifications 22 inch rims on a 2001 Monte Carlo SS?
i have forte 22" on nitto neo gen 235/30/22 and it has no rub
Whats the biggest 15 inch tire you can run on the rear of a 1985 Monte Carlo?
275/60/15 is the largest tire you can fit until you rub the frame with the side wall of the tire
Whats the normal engine operating temperature for a 83 Monte Carlo with a 305 and auto trans?
190 It is dependent on what thermostat you have in your engine. The engine will normally run hotter than the temp the thermostat opens at.
Can Whatsapp can be downloaded in Samsung Monte?
no, whats up is not working in samsung monte s5620.....
Where is the vacuum hose on a 96 mirage 1.8?
There is not one vacuum hose but rather a system of vacuum hoses. Open the hood and look on the plastic shroud that covers the radiator. It should have whats called a vacuum diagram. It shows the routing of all the vacuum hoses. They all need to be visually inspected and repaired or replaced if the are cracked , broken or have holes in them.
