Go to advance auto or Auto Zone and have them clear the computer code.
103ftlbs
Rod bearing (short for connecting rod bearing) Is the bearing where the connecting rod is attached to the rotating crankshaft.
wheel bearing, fork bearing,pedal bearing
Could be a bearing or a worn out crown and pinion set.
Center bearing should be replaceable after removing driveshaft
Hub/bearing assembly to steering knuckle bolts, 77 ft lbs.Axle nut, 103 ft lbs.
www.trailvoy.com All the answers for your Trailblazer from true enthusiasts.
Chances are its a wheel speed sensor and will need the wheel bearing replaced. or it can be a loose or corroded wire attached to the sensor as well.
THE BEARING ASSEMBLY IS NOT REMOVABLE FROM the hub. It's replaced as a unit.
The clutch bearing for an AC compressor is located in the center of the clutch. If the bearing goes bad, then the clutch is replaced as a whole part rather than changing the bearing.
I replaced a front wheel bearing on a 1998 GP for about $500 at a dealership. That was about 5 years ago. It's a big job to do yourself, even with air tools. The bearing is an assembly that is replaced as a unit.
The bearing lets the belt pully free wheel on the compressor input shaft that the clutch is attached to.