0
What else can I help you with?
How do you replace the crankshaft positioning sensor on a 1989 ford sho Taurus?
To replace the crankshaft positioning sensor on a 1989 Ford Sho Taurus, go near the water pump at the front of the car and remove components that block access to the sensor. Remove the two bolts holding the sensor in place remove the wire that sends data. Finally, replace the crankshaft positioning sensor.
How do you replace a camshaft positioning sensor on a 2002 Ford Explorer?
unplug wire remove 2 7/32 bolts remove sensor
How do you change the speed sensor on 1990 Chevy Celebrity?
The speed sensor on a 1990 Chevy Celebrity is on the top of the transaxle on the passenger side of the car. To change it unlatch and remove the wire harness then remove the two bolts that hold it in. The speed sensor can then be lifted out of the transaxle. To reinstall a new sensor reverse these steps.
Where is the crankshaft positioning sensor?
98 Hyundai crankshaft positioning sensor location
Why wont my car start when it turns over?
there are many different things that it could be check the camshaft positioning sensor, the throttle positioning sensor, and the crankshaft positioning sensor.
Where is the cam shaft positioning sensor on a 1997 Tahoe?
It is the only electrical part that's in the distributor. Remove the cap and rotor and you will see it.
How do you remove the cam shaft positioning sensor in a 2005 Ford F250 6.0 diesel?
I think the bolt is a 10mm then pull it out. Have not had many problems with the 6.0 cam sensor like the 7.3L
Where is the crankshaft sensor?
98 Hyundai crankshaft positioning sensor location
Where is the throttle positioning sensor on a 1989 Oldsmobile with a 2.8 Liter 6 cylinder engine?
The throttle positioning sensor is located in the throttle body.
Where is the crankshaft positioning sensor located on a 2000 Mercedes e320?
The 2000 Mercedes-Benz E3 20 crankshaft position in sensor is located on the back of the crankshaft. You will need to remove the rear engine cover in order to see the sensor.
Changing the camshaft positioning sensor on a 98 GMC JIMMY?
To change the camshaft positioning sensor on a 98 GMC Jimmy you need to first locate it. The sensor is located within the distributor. Next, unbolt the old sensor and replace with a new sensor.
How do you do you change the crankshaft positioning sensor on a 1992 Oldsmobile 88?
To change the crankshaft positioning sensor on a 1992 Oldsmobile 88, first, disconnect the negative battery cable for safety. Locate the sensor, which is typically found near the crankshaft pulley, and remove any components obstructing access. Unscrew the old sensor, disconnect the wiring harness, and install the new sensor by reversing the process. Finally, reconnect the battery and check for proper operation.
