answersLogoWhite

0

98 Hyundai crankshaft positioning sensor location

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is the crankshaft sensor?

98 Hyundai crankshaft positioning sensor location


Where is the crankshaft positioning sensor on 2003 Kia Sorento?

Can someone anyone please tell me where is the Crankshaft Positioning Sensor on a kia sorento 2005 and I also need a diagram


Why wont my car start when it turns over?

there are many different things that it could be check the camshaft positioning sensor, the throttle positioning sensor, and the crankshaft positioning sensor.


How do you replace the crankshaft positioning sensor on a 1989 ford sho Taurus?

To replace the crankshaft positioning sensor on a 1989 Ford Sho Taurus, go near the water pump at the front of the car and remove components that block access to the sensor. Remove the two bolts holding the sensor in place remove the wire that sends data. Finally, replace the crankshaft positioning sensor.


Where is the crankshaft positioning sensor on a 99 Elantra?

The crankshaft position sensor (CKP)is located on the front side of the engine block,near the flywheel/driveplate


Crankshaft positioning sensor location?

This sensor provides a signal to an engine management computer or an ignition control module or igniter indicating the position of the crankshaft.


Crankshaft positioning sensor location Chevy S10 2.2l?

You will find the crankshaft position sensor on the passengers side of the engine block, close to the starter.


What is BMW diagnostic code po340 mean?

Crankshaft positioning sensor fault.


Where is the crankshaft positioning sensor located on a 2000 Mercedes e320?

The 2000 Mercedes-Benz E3 20 crankshaft position in sensor is located on the back of the crankshaft. You will need to remove the rear engine cover in order to see the sensor.


Crankshaft positioning sensor 1994 Honda civic D16Z6 motor?

its located in the distributor.


Where is the crankshaft postioning sensor on a 97 Nissan pickup xe 2400?

The 1997 Nissan pickup truck crankshaft position eight sensor can be found on the back of the engine. The positioning sensor will be halfway down the engine block.


How do you do you change the crankshaft positioning sensor on a 1992 Oldsmobile 88?

To change the crankshaft positioning sensor on a 1992 Oldsmobile 88, first, disconnect the negative battery cable for safety. Locate the sensor, which is typically found near the crankshaft pulley, and remove any components obstructing access. Unscrew the old sensor, disconnect the wiring harness, and install the new sensor by reversing the process. Finally, reconnect the battery and check for proper operation.