Remove the tank again and remove the sending unit ,anspect it and reinstall it.
the fuel guage in the tank is faulty the tank has to be dropped and it replaced either that or is simply a broken wire to the tank
Sounds like the float needle is stuck in the open position.
The fuel tank will need replaced. There is a vent valve made into the top of the tank that has stuck and is not repairable.
When "bleeding" an oxygen tank, you are releasing excess pressure stored in the regulator, not the tank itself. If the excess pressure remains, it can damage the regulator, and the guage needle can get stuck, giving an inaccurate reading of how much oxygen remains in the tank.
If it is stuck there it means that your float in the gas tank is stuck or you have lost power between the sending unit and the fuel gauge. If you are not an experienced mechanic don't try adding power to it because you can and probably will cause the gas tank to blow up.
No fuel in tank; clogged line at/in the fuel tank; clogged fuel filter; carburetor needle valve is closed, fuel float stuck closed. Disconnect fuel line at carb, if you have fuel there, the problem is at the needle valve or float; if no fuel. the problem liies between the carb and the tank, next methodical check would be the fuel filter, etc.
wat happend to my friend when his fuel gauge got stuck,.. he just filled his gas tank to the top.. and it got unstuck.. but most likely its the lever inside ur gas tank.. u can just replace dat.
eather the gage is broke, or the floats stuck, try hitting the side of the gas tank with a hammer,lightly. Plus, have you drivin the car in a while? the needle could simply be stuck.
In some roles, it was replaced by the M41. As a main battle tank, it was replaced by the M47 Patton.
The sensor is located underneath the coolant recovery tank. On a 1999 Cavalier, there could be some sludge built up underneath the tank. Unfortunately the sensor alone cannot be replaced, the entire tank and sensor comes as one piece and must be replaced. tap on the side of your fill/overflow tank where the sensor is located sometimes they get stuck
The task of selecting a right and efficient water tank manufacturer among the crowd of tank manufacturers is like finding needle in a haystack.
problem is either in the guage cluster or the fuel sending unit inside the gas tank either one must be replaced most likely the tank sending unit take to a mechanic for proper diagnosal