0
What else can I help you with?
Kawasaki bayou 220 and when i turn on the mtor and get it runnin and gas just starts leaking out but still gets gas to the motor I found where it leaks its a little cord that is just hanging out Help?
the floats in carb are sticking.remove carb and clean out carb replace float needle.
What could make my 86 Chevy 350 motor die when i let off the gas i have soaked the carb changed the plugs adjusted the idle screw can t find any vacuum leaks any ideas at all?
Sounds like you still have carb issues. You say you soaked the carb, was the carb disassembled, parts soaked, cleaned, and reassembled with a carb rebuild kit? If not, that is what you need to do.
How do you rebuild 71 dodge 6 carb and diagram Where can I get a diagram of this 71 Dart slant 6 225 one bbl. Holly carb?
when you buy a rebuild kit for it it should have instructions, very simple carb to rebuild.
Can you put a carb on an injected motor?
no
How do you install carb linkage on a 64 dart slant six?
get a chiltons repair manual from the library for your year dodge.
What causes a Briggs motor to idle up and down?
Dirt in the carb or carb out of adjustment or both.
Is a carter 2 barrel carb model BBd compatible with a 1975 dodge dart with a slant six?
most 225 slant 6's were 1 bbl's unless it was the super six and it had a 2 bbl.
Where can you get carb adjustment specs for a 1983 Ford E150 351 motor Ford Co 2 barrel?
if you got a carb rebuild kit most of them have the tolerances in them. if not there are maunals on that motor on eBay for that year motor
How do you know which edelbrock carb is on your GM 305 motor?
You will have to look on the carb and get the numbers on it and then go to the Edelbrock website.
My 92 jeep wrangler leaks gas when i start it?
Broken fuel line? Carb.? Float stuck?
Why does Briggs straton let oil in carburetor?
there should never be oil in the carb. if there is then you have a problem. have you tipped the motor on its side on the carb side?
What is a reason a banshee leaks from the carburetor?
If you are referring to leaking out of one of the overflow hoses, your float is sticking. If it is leaking from the body of the carb, the gasket where the carb and float bowl bolt together needs to be replaced.
