The swim bladder is deflated. It will heal.
You might have debris stuck between the wier and the skimmer mouth. Or your deck or bond beam may have shifted slightly causing the wier (skimmer door) to stick. You might be able to shave a little off the sides of the wier to allow it to work.
A skimmer weir is the plastic flap and the opening of the skimmer. It traps leaves that are pulled into the skimmer when the pump is running and then holds the leaves in the skimmer whne the pump shuts down
if your talking about the plane skimmer there is no skimmer but there is a very simulair plane called a dodo
Purple Skimmer was created in 1922.
Widow Skimmer was created in 1839.
Can you eat the Black Skimmer
The Dragonfly Pulse surface skimmer
an african skimmer's bill let's it adapt
Black-tailed Skimmer was created in 1758.
You only use the skimmer/s
To get debris out of skimmer lines once the skimmer has been replaced, you need to blast air or water through the lines to push everything out of them. The lines must be disconnected at both ends during this process.
Drain the pool until the water level reaches two inches below the skimmer faceplate , remove the face plate using a screwdriver , remove the faceplate and skimmer , then replace the gasket and attach the skimmer and then the faceplate