Ignition switch worn out and needs to be replaced? After 20 years
check fuses,see if ones blown check power at blower, don't forget the fan switch ,there famous for going out.
Your ignition switch has failed. There is a good chance that the wiring plug for the switch has melted slightly due to a blower motor that is pulling too many amps. You will have to replace the switch, plug, and blower motor.
The blower motor relay switch in the Honda Civic is located at the center of the engine closest to the firewall. The relay is engaged when the ignition is turned to the on position.
can i use a tester for GBI 22v leaf blower to see their a spark on ignition on blower
probablly a bad ignition switch or blower motor not sure on that should run without power
bad relay
Yes. The blower motor of an air handler unit can be considered as an ignition source.
Yes. The blower motor of an air handling unit can be considered as an ignition source.
On my 1989 you first remove the engine coolant reservoir as the blower motor is right behind it. Disconnect the two wires, remove about 10-12 screws around the motor. Then twist, turn, and wiggle the motor out. It's a pretty tight fit so it won't be the easiest thing to get out.
It is supposed to run on the lowest setting when the ignition is on.
it's a problem with the blower motor resistor,
Bad blower resistor?