I would pull the trouble codes. This is a OBD 1 so you just need a paper clip to do it. My guess is you have a bad TPS switch. (throttle position switch)It should be located very near where the air cleaner hose attaches to the engine. It is usually a small flat black( size of a BIC lighter) item about 3-4 wires on it. When they are bad sometimes while the engine is running if you tap them the engine will kill.
replace brake booster
You will need to find your brake fluid reservoir to check the levels on your Grand Scenic. This will be on the master cylinder in the engine bay.
Either your parking brake ( emergency brake ) is on or the brake fluid level in your brake master cylinder in your engine compartment is LOW
The 1993 Jeep grand Cherokee brake light switch simply plugs in and out. The brake light switch is located beneath the dashboard on the drivers side of the engine compartment.
How do i replace brake lines on a 2000 grand am
The brake fluid reservoir cap in a 2002 Grand Prix is located on top of the brake fluid reservoir. This is usually located on the master cylinder, on the top side of the firewall between the cabin and the engine compartment.
The red " BRAKE " light in your dash means that either your parking brake is on or the BRAKE FLUID LEVEL in your brake master cylinder in the engine compartment is LOW
the master cylinder is whats bad
A 2005 Jeep Grand Cherokee uses DOT 3 fluid.
It is important to maintain the brake fluid levels in a car. The brake fluid type for a 2002 Grand AM is DOT 3 brake fluid.
2004 dodge grand caravan 4.0sxt cuts up when apply brake in gear and rpm go up and down.
Either under the dashboard on the driver's side or in the engine compartment.
Change the brake rotors
brake rotors out of round
you can't reset the brake light the computer automatically detects problems so if it hasn't shut off after a few engine cycles there is a problem with your braking system
The engine does not have to be running to release the parking brake on your 1994 Cadillac Seville. The parking brake can be engaged or released without the engine running.
Check the sensor on the brake pedal arm.
The emergency or parking brake on 2003 Jeep Grand Cherokee operates a set of brake shoes inside a hub on the rear axles, this is incorporated into the disc brake setup.
When Exhaust brake is on squeak noise comes from the engine?"
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
You're talking about an engine compression brake, commonly referred to as a Jake Brake.
out of brake fluid?
You will need to remove the tire and wheel from your 1998 Pontiac Grand Am. Remove the brake assembly spring from the brake pads. The brake pads will come off. Reverse the process to install the new brake pads.
The power brake reduces the driver's effort to brake by enlisting the engine to boost brake pressure. The Power Brake system is designed in such a way that should the engine fail, the brake will still work one more time.
Check the brake light switch ,on the brake pedal. Might need adjusting.