Best Answer

a slipping transmission, a bad tourqe converter, wrong firing order, wrong gap on the plugs, dist. cap put on wrong, to name a few.

2006-08-16 03:10:28
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: Your 1992 Mercury Cougar 6cyl 3.8 liter car is hesitating when you give her gas you did a tune up changed Dist cap rotor plugs fuel filter oil change and it is still hesitating what could it be?
Write your answer...

Related Questions

How do you change water pump on 1993 Mercury Cougar?

how do you change a water pump on 1993 Mercury Cougar

How do you change a fan switch on a 2000 Mercury Cougar?

How do i find the instructions for changing out the fan switch assembly in a 2001 Mercury Cougar?

Change spark plugs for 99 Mercury Cougar?


Wrench light on 2000 Mercury Cougar?

You need an oil change.

How do i change a transmission filter on a 94' Mercury Cougar?


How many hours of labor is it to change a timing belt in a 2001 mercury cougar?

The belt should be changed every 120,000 miles. This is about 1-2 hour job.

How do you change the side glass in a Mercury Cougar?

Take it to theglass repair guy

How long does it take to change a fuel pump in a 1991 Mercury Cougar LS?

It will take a skilled mechanic approximately 5 hours to change the fuel pump in your 1991 Mercury Cougar. It can take a novice mechanic much longer.

How do you change transmission filter on 2002 mercury cougar?

the transmission has to be spit apart in order to change the trans filter.

How do i get the change oil light to go off after I've changed the oil in my 1989 mercury cougar?

disconect the battery cables for a couple of miniutes. that should do it. At Least 10 Minutes for battery disconnect

How do I change the fuel pump relay on a 2000 Mercury cougar?

relays just plug in to the fusebox

How do you change an oil pan gasket on a 99 mercury cougar V 6?

lift the engine

When did Mercury change the 9.8 to 9.9?

they changed it it 1986

How much oil does a 1991 Mercury Cougar need?

According to my Chilton's Auto Repair Manual : For the 3.8 liter V6 engine in a 1991 Mercury Cougar : With engine oil filter change : ( 5.0 US. quarts )

How do you change the tire 99 mercury cougar?

Replacing the tire on a 99 mercury cougar is fairly easy. Jack up the car, remove the rim bolts and the tire will come off. Put on new one and reassemble.

How do you change automatic antenna in a 1996 Mercury Cougar?

Remove the wiring harness from the bottom of your 1996 Mercury Cougar automatic antenna. Remove the retaining nuts at the bottom of the antenna. Reverse the process to install your new automatic antenna.

How do you change the transmission on a 2001 Mercury Cougar?

Remove radiator cap. Push Cougar out of the way. Push a better car under the radiator cap. Install radiator cap.

How many quarts of oil does a 99 v6 cougar take?

The Owner Guide for the 1999 Mercury Cougar shows ( 5.8 quarts with filter change ) for the 2.5 liter V6 engine

How do you change the oil pan gasket in a 94 mercury cougar xr7?

you have to raise the motor or drop the k member, or both

What is Engine oil capacity 1995 mercury cougar 4.6 liter?

I'm assuming it is the same as the ( 1996 ) Mercury Cougar 4.6 liter V8 : With engine oil filter change : ( 5.0 U.S. quarts should put you almost to the full mark )

How many liters of oil for a 2000 mercury cougar 2.5 engine?

According to the 2000 Mercury Cougar Owner Guide : With engine oil filter change : The 2.5 liter V6 engine takes ( 5.5 liters of 5W-30 engine oil )

Do you need to change the timing belt on a 1999 Mercury Cougar V6?

The 2.5 liter " Duratec " V6 engine used in a 1999 Mercury Cougar uses ( 2 ) timing CHAINS , both located at the front of the engine ( 1 chain to each cylinder head )

How do you change the light behind the odomitor and clock in a 1999 Mercury Cougar?

You have to pull the gauge assy out and the lights are mounted from the rear. Run1

How do you change the struts on a 2000 Mercury Cougar?

Check out's repair guides online, under suspension, they have a good guide for doing it.

How do you change a wheel bearing on a 1999 Mercury Cougar?

Remove the tire and wheel from your 1999 Mercury Cougar. Remove the axle end. Remove the wheel bearing retaining nuts. Remove the wheel seal and the wheel bearing. Reverse the process to install your new wheel bearing.